Paradox Security Systems 307USB Instructions

Direct Connect Interface (307USB)
Instructions
307USB-TI08
English
Introduction
The Direct Connect Interface (307USB) allows for direct on-site communication
between a computer and a control panel. It can also be used to upgrade your
control panel's firmware.
Compatibility
• All Digiplex and Digiplex EVO control panels
• MG-6060/MG-6030, MG-6160/MG-6130
• Spectra Series
• MG5000/MG5050
• NEware end-user management software
• WinLoad installer upload/download software
Hardware Installation
See Figure 1
English
PC Link USB PC Link USB
Green LED ON LED verde prendida:
If communication is Si se logró la communication
established between the entre la computadora y el
computer and the module módulo
Product Link Product Link
Green LED ON LED verde prendida:
When connected to panel Si conectado a la central y el
during normal operation funcionamiento es normal
Green LED OFF LED verde apagada
Not connected properly Conexión y/o alimentación
and/or powered properly. incorrecta(s).
Rx/Tx Rx/Tx
Green LED Flash LED verde parpadea
Flashes when receiving or Parpadeo al recibir o
transmitting data. transmitir datos.
USB: max lenght 8m or USB: máx. extensión de 8m
25ft ó 25ft
DB9: max lenght 5m or DB9: máx. extensión de 5m
15ft ó 15ft
Español Français
PC Link USB
DEL verte activée
Si la communication est
établie entre l'ordinateur et
le module.
Product Link
DEL verte activée
Si raccordé au panneau et
que le fonctionnement est
normal
DEL verte désactivée
N'est pas bien raccordé et/
ou alimenté.
Rx/Tx
DEL verte clignote
Clignote lors de réception
ou transmission de don-
nées.
USB :longeur maximale de
8 m ou de 25 pi
DB9 : longeur maximale de
5 m ou de 15 pi
Installation and Setup
USB Connection and Setup
If using a USB cable instead of a 9-pin serial cable (DB-9) to connect to the
computer, the USB driver must first be installed on the computer. The driver is
available on the WinLoad and NEware CD, and on the Paradox web site
(paradox.com).
1. If retrieving the USB driver from the WinLoad or NEware CD, insert
CD into computer drive. If retrieved from the Paradox web site,
save and extract the appropriate .zip file (XP64_Vista64
DriverFiles ZIP or Win2000_XP_Vista DriverFiles ZIP or Win98
DriverFiles ZIP) to the computer.
2. Connect the USB cable from the 307USB module to a USB port on
the computer.
3. Follow the on-screen instructions. If the USB driver was obtained
from the Paradox web site, you will need to browse the computer
when prompted for the required files.
WinLoad Setup
The COM port that 307USB is connected to on the computer must be defined in
WinLoad. Start WinLoad and then make sure that all client accounts are closed.
From the menu bar click Setup
connection tab. Click the COM port to which 307USB is connected. When
finished, click Close.
NEware Setup
The COM port that 307USB is connected to on the computer must be defined in
NEware. Start NEware by clicking on Start
appropriate edition. From the connection window, click Communication Setup,
click the COM port to which 307USB is connected and then select the
communication speed (BPS - baud rate). Note: Be sure to select the same
baud rate as set in the control panel. When finished, click OK.
Figure/Figura 1: LED properties/ Propiedades de las luces
LED / Propriétés des DEL
DB9
Cable/
Câble
PC LINK USB
DB9
Rx/Tx
OR
O
Digiplex Panel
OU
Connections, and then click the Direct
Programs NEware
OR
O
OU
USB Cable / Câble
Product Link
307USB
USB
Magellan Panel
and the