The Procter & Gamble FEBREZE OdorGrab FHT150 Serie Mode D'emploi page 5

INSTALLING FEBREZE
The OdorGrab T
™
• Turn off and unplug the air cleaner.
• Turn the air cleaner upside down on a flat surface. Gently remove the base by pulling
it upwards.
• Remove the filter by grasping the edges of the filter frame or the ribbon tab.
Pull away from tabs and up to remove.
• Remove the protective plastic from the Febreze
• Insert the fresh filter into the unit with the ribbon tabs facing you. This will allow for
easy removal the next time you have to replace the filter.
Note: The OdorGrab
INSTALLING THE FEBREZE
®
One Febreze scent cartridge is supplied
with your new air cleaner. It is packed in
the same plastic bag as this Instruction
Manual. It is sealed for freshness.
• Turn off and unplug the air cleaner.
Open the door on the Scent Cartridge
compartment on the back of the unit.
(See next page for location)
• Peel the foil layer off the cartridge
by pulling on the tab. Once removed,
immediately dispose of the foil layer.
A thin clear film with perforations
will remain attached to the cartridge.
DO NOT REMOVE.
CAUTION: EYE IRRITANT. Avoid contact with
eyes. Do not touch the scent pad located within the
cartridge. Contains fragrance oils. See page 3 for
FIRST AID treatment if necessary.
Filter is supplied within the air cleaner. It is wrapped to ensure purity.
Filter is not washable. Do not immerse in water.
™
ODORGRAB
®
® OdorGrab
™
SCENT CARTRIDGE
®
FILTER
™
T Filter.
5