DOMENA HYGIAFlor Instructions page 23

AUFBEWAHREN
WEGRÄUMEN MIT SENKRECHTER
POSITION DER RÖHREN
Der Dampfreiniger kann weggeräumt werden mit
dem Dampfrohr in senkrechter Position.
• Setzen Sie den dazupassenden Clip an einen
der beiden Röhren, und hängen Sie ihn oben auf
einen der beiden „Blumenblätter".
AUFBEWAHREN
• Nach dem Reinigen schalten Sie mit dem Ein-/
Aus- Schalter das Gerät aus.
• Das komplette Zubehör kann zwischen den
„Blumenblättern" verstaut werden.
• Das Netzkabel und das Dampfkabel werden um
den Sockel des Gerätes herumgerollt.
PFLEGE
• Für die Außenreinigung des Geräts einfach
ein feuchtes Tuch benutzen. Die Benutzung
von Lösungs- oder Reinigungsmitteln, die die
Oberfl äche beschädigen könnten, vermeiden.
WHAT TO DO IF...
PROBLEMS CAUSES
None of the - Power supply problem
lights are lit. The - Appliance not plugged in or On/Off
generator does not button not pressed
heat up. - Other
No steam is
produced
- The reservoir is empty
- The reservoir is incorrectly inserted or
has not been inserted.
- The anti-scale cartridge has not been
inserted
- The anti-scale cartridge is incorrectly
inserted in the reservoir
- The cartridge lifetime pilot light is on
- Other
The machine - There is no water in the reservoir
makes a noise - The reservoir is incorrectly inserted or
has not been inserted.
- Other
The supply of steam - Long periods of steaming
is interrupted
Indicator "AUTO- - Auto-Stop activated after 10 minutes
STOP" is lit of non-use
ANTI-CALC pilot - Anti-scale cartridge needs to be
light fl ashes or is lit replaced
The on / off pilot - The appliance is not ready.
light fl ashes - The appliance is not functional
STORAGE
STANDING POSITION :
The steam cleaner can rest in standing position.
- Set the position clip on one of the extension
tubes and fi x it on the top of one petal.
STORAGE
• After cleaning, press the On/Off button to switch
the appliance off .
• All accessories can be put away between both
petals.
• The power cord and the fl exible hose can be
wound around the base of the appliance.
MAINTENANCE
• To clean the body of the appliance, simply use
a moist cloth. Do not use solvents or detergents
which may harm the body material.
SOLUTIONS
- Check the plugs and mains
- Plug in the appliance and press the On/Off button.
- Go to your local dealer
- Press the steam button on the pistol handle. Use the
MAXI steam output.
- Fill the reservoir
- Insert the reservoir and replace the tank cap
- Insert an anti-scale cartridge into the reservoir
- Insert the anti-scale cartridge correctly and replace the
tank cap
- Change the anti-scale cartridge. Press the steam button
- Go to your local dealer
- Fill the reservoir
- Insert the reservoir and replace the tank cap
- Go to your local dealer
- Wait until the indicator light illuminates again before
requesting steam.
- Press the steam ON/OFF switch: the pilot light goes off
and the appliance starts heating again.
- Replace the cartridge. Switch the appliance off
and back on. Wait until the on/off pilot light is
permanently on.
- Wait until the on/off pilot light is permanently on to
use the appliance.
- Check if any other pilot light - "AUTOSTOP" or "ANTI-
CALC" - is lit. Follow the procedures to have these
lights turned off .
- 23 -