Publicité
Les langues disponibles
Les langues disponibles
In this mode, the charging process will be different from ordinary charging mode. The internal processor
of the charger will monitor the voltages of each cell of the battery pack and controls the charging current
that is feeding to each cell to normalize the voltage.
The value on the left side of second line sets a charge current and the value on the right side
LiPo[0]
Balance
of second line sets the voltage of the battery pack.
2.0A
11.1V(3S)
After setting the current and voltage press Start/ Enter key for more than 3 seconds
to start the process (Charge current: 0.1-6.0A, Voltage: 2-4S).
This shows the number of cells you set up and the processor detects. "R:" shows the number of cells found
by the charger and "S:" is the number of cells "S:" is the number of cells selected by you at the previous
screen. If both numbers are identical you can start charging by press Start/Enter button. If not, press Batt
type/Stop button to go back to previous screen. Then carefully check the number of cells of the battery pack
to charge again.
The screen shows the present situation during charge process. To stop charging
press Batt type/Stop key once.
"FAST" CHARGING LITHIUM BATTERY
The charging current is getting smaller as the process goes to the near end term of Lithium battery
charging. To finish charging process earlier, this program eliminate certain term of CV process. Actually,
the charging current will goes to 1/5 from the initial value to end the process while the normal charging
goes to 1/10 during CV term. The charging capacity may be a bit smaller than normal charging but the
process time will be reduced.
You can set up the charging current and the voltage of the battery pack being
LiPo[0]
FAST CHG
charged. As you press Start/Enter button the voltage confirmation will be displayed.
2.0A
11.1V(3S)
And then, if you confirm the voltage and current, press Start/Enter button again to
start charging.
This shows the present state of "FAST" charging. To stop charging arbitrary, press
Batt type/Stop key once.
"STORAGE" CONTROL LITHIUM BATTERY
This is for charging or discharging Lithium battery not to be used for the time being. The program will
determine to charge or discharge the battery to the certain voltage depending on the voltage of the
battery at its initial stage. They are different from the type of the battery, 3.85V for Li-Po, 3.70V for
Li-Ion, 3.3V for Li-Fe, and 3.85V for Li-Hv per cell. If the voltage of battery at its initial stage is over the
voltage level to storage, the program will start to discharge.
You can set up the current and the voltage of the battery pack to be charged. The
LiPo[0]
STORAGE
current will be used for charge or discharge the battery to reach the "storage" level
1.0A
11.1V(3S)
of voltage.
9
Publicité
