Publicité
Les langues disponibles
Les langues disponibles
• The accumulator must only be recharged with the charging device supplied by the manufacturer.
Do not use any other charging devices in order to avoid damages.
• If the lamp is not in use, the charging device must be removed from the socket.
• If possible, use the lamp in dry locations only. Under no circumstances use it continuously in moist or
wet locations.
• For disposal, the lamp and the Lithium-Ion battery must be handed over to the
respective public recycling system.
Caution
Electrical energy can cause serious injuries. In order to avoid electrical shock, injuries or fire the fol-
lowing safety instructions have to be observed and respected:
• Ensure cable and housing are not damaged. Lights and charging stations that have fallen down or
that are damaged, must be checked by qualified personnel before restarting operation.
• When laying the power supply lead, ensure it does not come into contact with hot or sharp parts
and that it cannot be damaged in another way. The lead is to be laid in such a way that it does not
constitute a risk of stumbling.
• The charging station and work light must not be exposed to water or other liquids. Dangerous volt-
age discharge may occur.
• Service and repair work should be carried out by qualified technical personnel only. In order ensure
the working reliability in the long term, always use original spare parts.
• The charging station and/or the work light must not be disassembled. Inappropriate assembly can
lead to a reduction of the functionality, to fire, to electrical shocks and/or to injury.
• Do not remove any safety devices.
• Never look directly into the light – the light intensity is strong enough to cause eye injuries.
• If an extension cord is necessary, it must be sufficiently dimensioned for the charging station. Cables
which are not appropriate for the necessary amperage may overheat.
• When recharging, both the work light and the charging station slightly warm up which does not
reduce their functionality. When working with the work light, appropriate caution is required.
• Only use the work light within the prescribed places, and governed under the current regulations
relating to the working environment and to electrical systems.
Warranty
Any claims against the manufacturer and/or its authorized agents because of damage caused by
improper use of the tool are void. Improper use of the tool is defined as:
• products which are altered, modified or repaired by anyone other than ViGOR-Equipment;
• subject to abuse, improper use, negligence,accordance with normal practices or the instructions
and specifications of ViGOR- Equipment;
• used in conjunction with any product, device, component or system, that is either defective, the
source of a defect, or not reasonably intended to be used in conjunction with this product.
Product Name:
2.5 Watts Chip-On-Board LED Hand Lamp
Article No.:
ViGOR V 2740
We declare that the product which this declaration relates is in conformity with the requirement of the
standards of the EMC Directive (2004/108/EC) and the Low Voltage Directive (2006/95/EC).
Furthermore, we declare that the a/m article is in conformity with the requirements of
the following standards:
DIN EN 55015:2006+A1:2007+A2:2009;
DIN EN 61000-3-2:2006+A1:2009+A2:2009
DIN EN 60598- 1:2008+A11:2009;
Date: 17-07-2012
Hermann J. ZERVER
ViGOR GmbH & Co. KG •Am Langen Siepen 13 - 15 • D-42857 Remscheid
info@vigor-equipment.de • www.vigor-equipment.de
4
DIN EN 61547:2009;
DIN EN 61000-3-3:2008;
EN 60598-2-4:1997
Publicité
