Little Seeds 6857096BRU Manuel D'assemblage page 35

Step 27
IMPOBTANT: THIS UNIT MUST BE SECURE TO THE WALL TO HELP PREVENT TIPOVERl
FOLLOW THESE INSTRUCTIONS TO INSTALL THE ANTI-TIPPING SAFETY BRACKET
PROVIDED WITH THIS PRODUCTl
WABNING
SPPPPuP PP fPtPl PPuPhPng PnjuPPPP
can occur from furniture tipover.
To prevent tipover:
* Install tpover restraint provided
* place heaviest items in the lowest
drawers
* Unless specifcally designed to
allomodate, do not set TVs or other
heavy objects on the top of this
prodult
* Never allow children to climb or
hang on drawers, door, or shelves
* Never open more than one drawer
at a tme
Use of tipover restarints may only
PPduPP, but nPt PlPmPnPtP thP PPPP
of tipover
OPTION 1: Attachment into a wall stud (preferred method)
Using a stud fnder, locate a stud in the wall. Place your unit against the wall, with the safety bracket
aligned in this locaton.
To make driving the screw easier, you can drill a 1/8" diameter pilot hole (3mm) through the safety
brallet into the studl
Drive the screw through the safety bracket into the wall stud. Tighten the screw that was not fully
tghened in step 1.
OPTION 2: Attachment into drywall
Lolate your unit where desired against a wall and marl the wall through the safety brallet, then
move your unit aside.
Drill a 3/16" diameter hole (5mm) into the wallboard. Tap the wall anchor into the hole untl it is flush.
Move your unit into locaton and fasten the wall bracket to the wall anchor with the screw.
Tighten the screw that was not fully tghtened in step 1.
lil leseedslidsllom
For Masonry, Concrete, or other
wall materials:
Consult your lolal hardware store
for appropriate anlhors to selurely
alach the safety bracket.
35
TM
hole
stud
wallboard