Publicité
OPERATION / OPÉRATION / DIE ANWENDUNG / OPERACIÓN / FUNZIONAMENTO
1
OPERATION / OPÉRATION / DIE ANWENDUNG / OPERACIÓN / FUNZIONAMENTO
EN
CAUTION! During operation, a stone or root may
become lodged in the Tines, or tall grass or weeds may
become wrapped around the tine shaft.
To clear the tines or tine shaft, release the Trigger Lever,
wait for the Tines to come to a complete stop and
unplug the Tiller.
Wearing suitable safety gloves carefully dislodge or
remove the foreign matter from the Tines or Tine Shaft.
To simplify removal of tall grass or weeds from the Tine
Shaft, remove one or more of the Tines.
IMPORTANT: Move the Tiller to the work area prior to
starting the motor.
Use the Tiller for breaking soil, preparing seed beds,
and for cultivating gardens and flower beds. The Tiller
can also dig small holes for planting saplings or potted
plants.
NOTE: For breaking sod or deep tilling, allow the Tines
to pull the Tiller forward to the end of your arm's reach,
then firmly pull it back towards yourself. Best results will
be achieved by repeatedly allowing the Tiller to move
forward and pulling it back.
CAUTION: By pulling the Tiller back towards yourself,
the Tines will dig deeper and more aggressively. To
prevent tripping, take extra precautions when moving
backwards and when pulling the Tiller back towards
yourself.
A5P | 01
NOTE: If the Tiller digs deep enough to stay in one spot,
gently rock it from side to side until it starts to move
forward again.
CAUTION: When working on inclines, always stand
diagonally to the inclines to retain a firm, safe footing.
Do not work on extremely steep slopes.
WARNING! Never pass the Tiller over the extension
cord. Make sure the cord is always in a safe position
behind you.
For preparing seed beds, we recommend using one of
the following tilling patterns.
CAUTION: Before moving the Tiller from
one area to another, switch off the motor and wait for
the Tines to come to a complete stop. Be careful not to
let the Tines touch the ground whilst moving the Tiller.
The Tines, as well as the unit itself, may be damaged
even if the motor is switched off.
To stop the Tiller, simply release the Trigger Lever.
WARNING! Ensure the Label "FRONT" is pointing away
from your body.
2
Publicité
