Publicité
Les langues disponibles
Les langues disponibles
REMOTE CONTROL
1. SOURCE Butto
2. Standby Button
(Previous)
3.
TUNE-(Tune Down)
(Next)
TUNE+(Tune Up)
4. VOL-/+(Volume Down/Up)
5.
Mute Button
P
lay/Pause Button
6.
7. ST/MO(Stereo/Mono) Button
8. EQ(Equalizer)
BATTERY INSTALLATION
- Before installation
Remove and discard the insulation tab. Out of the box the Remote Control
has a battery and will be usable after the tab is removed.
-Replace battery for the remote control
1. Push and slide out the battery holder as Figure 1 below.
2. Replace the battery with a new CR2025 button cell with the polarity (+)
side upward.
3. Slide into the battery holder.
Battery precautions
• Never recharge the batteries, apply heat to them or take them apart.
• Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
• Do not throw the batteries in fire!
• Attention should be drawn to the environmental aspects of battery disposal.
• If the remote control is not going to be used for a long time, remove the battery
to avoid damage caused by battery leakage corrosion.
POWER CONTROL
- To turn the unit on
• Connect the supplied AC/DC adapter.
• Press STANDBY button to turn on the unit.
- To turn the unit off
• Press STANDBY button on the remote control.
NOTE:
If the unit is not used for a long period of time, disconnect the power adapter.
1
n
2
3
4
POWER
l
SOURCE
TUNE+
TUNE-
VOL
-
+
EQ
6
5
6
7
ST/MO
8
Publicité
