Scotts LB20040S Manuel De L'utilisateur page 4

INSTALLING BATTERY PACK (Fig. 2 )
•
Place the battery pack in the blower's battery port. Align
the raised rib on the battery pack with the groove in the
blower's battery port.
•
Make sure the latch on bottom of the battery pack snaps
in place and that battery pack is secured in the blower
before beginning operation.
REMOVING BATTERY PACK (Fig. 2 )
•
Release the trigger to stop the blower.
•
Press and hold the latch button at the bottom of the battery
pack.
•
Remove battery pack from the blower.
IMPORTANT: When placing battery pack in the blower, be sure the raised ribs on the battery pack align with the grooves in the
top of the blower. Make sure the battery is fully seated, and it latches into place properly. Improper installation of the battery
pack can cause damage to internal components.
STARTING /STOPPING THE BLOWER (Fig. 3 & Fig. 4)
•
To start the blower, Press the safety lock button and
push the trigger.
•
To stop the blower, release the trigger.
Battery tools are always in operating condition. Therefore,
operation trigger switch should always be in the OFF
(released) position when not in use or carrying/ moving the
tool.
Safety
lock button
Fig. 3
(Fig. 5)
AIR SPEED CONTROLS
•
Press the turbo button (A), to reach the maximum speed.
•
Press this button again to come to the normal speed.
Turbo button
Safety lock button
ASSEMBLY
OPERATING
Trigger
Fig. 4
Fig. 5
Model LB20040S
OPERATING THE BLOWER (Fig. 6)
To keep from scattering
debris, blow around the outer
edges of a debris pile. Never
blow directly into the center of
a pile.
Use rakes and brooms to
loosen debris before blowing.
In dusty conditions, slightly
dampen surfaces when water
is
available.
Save water by using blowers
instead of hoses for many lawn and garden applications,
including areas such as gutters, patios, grills, porches.
Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
After using blowers or other equipment, CLEAN UP!
Dispose of debris properly.
Do not at any time let brake fluids, gasoline, petroleum
based products; penetrating oils, etc. come in contact with
plastic parts. They contain chemicals that can damage,
weaken or destroy plastic.
Do not attempt to modify this tool or create accessories not
recommended for use with this tool. Any such alteration or
modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
To avoid serious personal injury, always remove the battery
pack from the tool when cleaning or performing any
maintenance.
4
Battery
Pack
Battery
Port
Fig. 2
Fig. 6