Publicité
Les langues disponibles
Les langues disponibles
Charging your device
The "power on" light will blink as long as the device is charging. The light will
go off as soon as the charging process is complete.
As soon as the charge drops below 3V, all lights will blink 10 times and the
device will shut off automatically.
Your Skin Cell Tronic device comes with a rechargeable lithium battery. Please
make sure that you fully recharge it every time it runs down (see above).
You may use the device even while you are charging it. Before using it for the
first time, the device should be fully charged.
Now you are ready to try out this device
Place the device on a flat station and sprinkle a few drops of water on the
contact surface
Turn on the power, then press the sonic (ultrasound) button, select low or
high level
You know ultrasound waves are generated when the water drops start to vibrate
We recommend the use of our Vegas Cosmetics gel products for this treatment
process in order to facilitate and maximize transmission of the ultrasound waves.
While using the ionic function, you will hear a short beep every 5 seconds.
The beep will assist you in controlling the time line for the different treatment
steps (for example one beep for each impurity, or 5 beeps for a dark pigment
spot) and help remind you to move from point to point. You will also hear
an alarm tone after 10 minutes usage time and the device will shut itself off
automatically to end the treatment process. If you would like to do another
treatment session, just press the on button again and choose the options you
would like to use. Should you at any time during the treatment process want to
stop, press the off button.
20
Treatment Instructions
Apply the Vegas Cosmetics gel product onto your face (spreading it evenly
without massaging it into your skin) as well as onto the contact surface. Touch
the device to your face gently but ensure tight contact. If the device does not
glide smoothly over your skin you may want to add some more gel (generally
you will use 4 to 5 grams/0.14 to 0.17oz per application). It is very important
that you always apply sufficient quantities of gel to achieve smooth movements
of the ultrasound device. According to your skin type you may want to add gel
several times during the treatment process.
Move the device slowly within 5 seconds from your chin towards the ear.
Always move upward and symmetrically on both sides of your face.
General Care Instructions
The ultrasound device may be used up to three times per
week but never longer than 30 minutes per treatment.
First step:
Deep skin cleansing process
1. Remove makeup and cleanse face thoroughly
(we recommend Vegas Cosmetics Q10 Cleansing
Milk or Foam Cleanser from our Vegas Products.).
2. Apply sufficient amounts of cleansing lotion or
foam onto your face and the contact surface.
3. Press the On/Off button to turn the device on, select
the CLEANSE function using the COMBI button.
4. Begin your facial massage according to the
instructions in the nearby diagram regarding
movements and treatment steps. Use accordingly on
other treatment areas.
5. Rinse your face with water and apply a toner, i.e.
Vegas Cosmetics toner. Clean device.
We recommend the following Vegas Cosmetics
products: Aloe Vera foam and tonic, Q10 cleansing
milk, Hyaluron Care foam and Sensitive Concept
cleansing gel.
Photon ultrasonic anti aging device
Gel usage
approximately 4 to 5
grams/0.14 to 0.17oz
per application
5
6
4
3
2
1
21
Publicité
