Zodi Extreme SC Manual D'instructions page 2

DIRECTIONS - FOLLOW THESE DIRECTIONS AT ALL TIMES
Read, understand and follow the instructions printed in this instruction manual, on shower and on propane cylinder before
operating this product. Failure to comply with all instructions can result in serious bodily injury, death and/or property loss.
CARBON MONOXIDE HAZARD - Operating this item in an enclosed space can kill you. Never use this appliance indoors or
in an enclosed space such as a camper, tent, car, boat or home. Zodi assumes no responsibility for improper use. These
directions may refer to options not included on your model. Keep children & pets away from product when operating.
CAUTION
DO NOT OPERATE INDOORS. FOR OUTDOOR USE ONLY.
Propane products emit carbon monoxide which can kill you. Never use in enclosed space.
This package contains:
• Stainless steel shower with hand
• Tripod stove
• Storage bag
• Shower hose with showerhead
• Built-on shower pole holder
• Directions & warranty card
STEP 1
Check that gas valve is turned
off (turned clockwise). Attach
propane cylinder to gas valve
on stove. Inspect gas valve and
cylinder for debris and check for
leaks with soapy water.
STEP 2
Firmly connect the 3 legs to the
3 steel lugs on the stove ring.
Place stove outdoors on level
ground, clear of flammable
material and vapors.
STEP 3
Attach hose to Extreme by
twisting the brass fitting onto
the on/off valve. Turn clockwise
until finger tight.
STEP 4
Remove hand pump from water
tank by rotating handle
counter-clockwise without
pushing down. Do not place
pump back into tank until
after heating.
STEP 5
Coil shower hose around the
top of the tank and fill with
3 gallons of water.
(4 inches down from top)
pump & temp indicator
(shower pole sold separately)
STEP 6
Place filled tank on stove assembly.
Ensure tank and stove are stable
before heating.
CAUTION: DO NOT HEAT WITH
PUMP IN TANK.
STEP 7
Place match or lighter next to
burner and turn gas valve on.
Adjust burner so flame is
restricted under tank. Average
heat time is 6 to 12 minutes.
CAUTION: DO NOT OPERATE
PRODUCT INDOORS.
STEP 8
The thermometer will highlight
the water temperature with a green
background. Do not heat over
100°F. Once desired temperature
is obtained, turn stove gas
valve off.
STEP 9
Insert pump back into tank and
tighten by gently turning the handle
clockwise. Lifting tank at handle,
remove from stove, and place tank
on level dry ground, clear of debris.
Push red lever down to enable you
to pressurize the system.
STEP 10
Unlock pump handle by pushing
down on handle and twisting
counter-clockwise. Pressurize tank
by pumping the handle 15 times.
STEP 11
Start water flow by rotating red
lever up. To stop water flow, push
red lever down again. Average
shower length is 5 to 8 minutes.
Pump as needed to maintain
water flow. To release pressure in
tank, pull up on pressure release.