Publicité
Les langues disponibles
Les langues disponibles
fUNCTIONAl DESCRIPTION
1. Sander attachment
2. Sanding base
3. Sanding base tip
4. Sanding sheet
OPERATING INSTRUCTIONS
WARNING:
WARNING:
Risk of lacerations or burns. Do not touch work piece or accessory
immediately after operating the tool. They can become very hot. Handle carefully. Always allow
accessories and work piece to cool before handling.
WARNING:
To reduce the risk of injury, turn off and remove battery from tool or disconnect
plug from power source before making any adjustments or removing or installing attachments or
accessories. Remove any accessory from the attachment before removing or installing the attachment.
NOTE: Refer to Power Unit instruction manual before operating this tool for all safety warnings
and details on installing and removing attachments.
SANDING
Your tool is equipped with a teardrop base which allows you to use it on large flat surfaces and tight
spots or corners. The pad tips may wear unevenly, depending on use. The pads are designed to allow
you to interchange and /or rotate the diamond tip.
• To switch the tool on, press the variable speed switch. The tool speed depends on how far you
press the switch.
• To switch the tool off, release the variable speed switch.
NOTE: This attachment only operates in the forward direction, the forward/reverse slider of the
Power Unit should not be able to be switched to reverse.
NOTE: Do not rest fingers on platen during use. Move it in long sweeping strokes across
the surface, letting it do the work. Light pressure is all that is required for sanding. Excessive
pressure will slow the tool and produce inferior results. Check your work often, product is capable
of removing material rapidly. Excessive force will reduce the working efficiency and cause motor
overload. Replacing the sanding sheet regularly will maintain optimum working efficiency.
NOTE: Always ensure the workpiece is firmly held or clamped to prevent movement. Any
movement of the material may affect the quality of the sanding finish.
Attaching and removing sanding sheets (figure A)
The sanding attachment uses pre-cut sanding sheets.
WARNING:
To reduce the risk of injury, turn off and remove
battery from tool or disconnect plug from power source before attaching
or removing sanding sheets.
• Turn off and remove batttery or disconnect tool from power source.
• To attach a sanding sheet, line it up with the sanding base as shown.
• Press the sheet firmly and evenly onto the sanding base.
• To remove the sheet, pull it off the sanding pad.
NOTE: Never use the sanding attachment without a sanding sheet or accessory in place.
Use coarse grit paper to sand rough surfaces, medium grit for smooth surfaces, and fine grit
for the finishing surfaces. If necessary, first make a test run on scrap material. Allowing the
Shock hazard. Under no circumstances should this product be used near water.
3
2
4
4
1
A
Publicité
