PMA Ex-System A2 Mode D'emploi Et Instructions De Montage page 2

A
1
A. Conduit
B. Fitting
A
2
Cut the conduit straight in the corrugation (A).
3
Push in the conduit (A) with a slight twist until the stop.
The specifications and instructions for our customers in this document reflect
the product engineering level at the time of manufacturing. Please consider
the valid data sheet release at a time. For questions please contact the PMA
customer service. PMA AG accepts no liability for damages resulting from
unprofessional installation or application or misuse for a purpose. This dis­
claimer also includes damages to third parties. It is the cus tomer's responsibi­
lity to check the delivered products and immediately notify PMA AG of detec­
ted faults. It is also the customer's res ponsibility to test the delivered product
PMA AG (Headquarters) · Aathalstrasse 90 · 8610 Uster · Switzerland · Tel: +41 44 905 61 11 · Fax +41 44 905 61 22 · pma-ch.info@tnb.com · www.pma.ch
C
B
C. Universal safety clip
B
A
A
4
Pull back the conduit (A) slightly to ensure the locking mechanism is fully
engaged.
5
To re­open use a screw driver. The screwdriver slot at the oval clip (C) must
point towards the conduit.
ATTENTION
6
If bending the conduit, please keep to the recommended bending radius.
on its applicability for the intended purpose. PMA AG will accept no liability or
responsibility for their products if a product or a PMA system is combined or
used together with third­party products, i.e. products from other companies
than PMA AG. Jurisdiction in all legal disputes concerning product liability
have the courts of the canton of Zurich/Switzerland. Swiss law applies.
For more information and the latest data sheet releases go to: www.pma.ch
C
C