ASROCK PV530A-ITX Mode D'emploi page 10

Les langues disponibles

2.3 Installation of Memor

2.3 Installation of Memor y Modules (DIMM)

2.3 Installation of Memor

PV530A-ITX motherboard provides two 240-pin DDR3 (Double Data Rate 3) DIMM slots.

1. It is not allowed to install a DDR or DDR2 memory module into

DDR3 slot; otherwise, this motherboard and DIMM may be damaged.

2. DDR3 1066 memory module can only be installed in one of the

DDR3 DIMM slots. If you install two DDR3 1066 memory modules

on this motherboard, they will run at DDR3 800.

Installing a DIMM

Please make sure to disconnect power supply before adding or

removing DIMMs or the system components.

Step 1.

Unlock a DIMM slot by pressing the retaining clips outward.

Step 2.

Align a DIMM on the slot such that the notch on the DIMM matches the break

on the slot.

The DIMM only fits in one correct orientation. It will cause permanent

damage to the motherboard and the DIMM if you force the DIMM into the

slot at incorrect orientation.

Step 3.

Firmly insert the DIMM into the slot until the retaining clips at both ends fully

snap back in place and the DIMM is properly seated.

1 0

y Modules (DIMM)

ASRock PV530A-ITX Motherboard