DeWalt DCR010 Guide D'utilisation page 9

Fig. D
Mobile Phone Tray (Fig. A)
The speaker has a mobile phone tray
to hold the mobile phone while in use.

WARNING: A mobile phone cannot be secured
in the tray and can fall if the speaker is moved or
transported. Be sure to remove mobile phone from the
tray before transporting the speaker.
Mounting the Speaker (Fig. E)
The speaker is designed to be mountable or to sit upright
on a table or work surface. If mounting, use the mounting
slots found on the bottom of the speaker as a template
15
for the location of the screws on the wood or wall. Mount
the speaker securely using drywall screws (purchased
separately) at least 1" (25.4 mm) long with a screw head
diameter of 1/4" (5–7 mm), screwed into wood to an
optimal depth leaving approximately 7/32" (5.5 mm) of the
screw exposed. Align the slots on the back of the speaker
with the exposed screws and fully engage them in the slots.
The speaker can be mounted horizontally or vertically in
either direction.
Fig. E
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect battery pack
before cleaning, making any adjustments or
removing/installing attachments or accessories.
The speaker can operate off of DC power (a battery pack) or
with the AC power cord supplied.
Powering with the AC Power Cord (Fig. F)

WARNING: Use only the AC power cord
recommended for this product. Use of any other
external power supply could damage the speaker or
power supply.
9
10 which can be used
15
To power the speaker using the AC power cord, plug the
cord into the speaker's AC power input
back of the speaker, then plug the 120V AC cord end into
the wall outlet or an appropriate-sized extension cord that
is plugged into a wall outlet. Always fully extend the cord
before each use.
nOTE: The battery pack must be removed before the AC
power cord can be plugged into the AC power input.
Fig. F
Inserting and Removing the Battery Pack
from the Bluetooth® Speaker (Fig. G)
nOTE: Make sure your battery pack
To Install the Battery Pack into the
Speaker
1. Align the battery pack
12
speaker's battery port 14
2. Slide it in until the battery pack is firmly seated and
ensure that you hear the lock snap into place. Be sure
that it does not disengage.
To Remove the Battery Pack from
the Speaker
1. Press the battery release button
battery pack out of the battery port.
2. Insert battery pack into the charger as described in the
charger section of this manual.
Fig. G
English
11 found on the
11
is fully charged.
12
with the rails inside the
.
13 and firmly pull the
13
12
14
7