Pullman-Holt 390ASB Instructions D'utilisation Et D'entretien

Model 390ASB
Dry Canister Vacuum Cleaner
This product is a high performance dry canister vacuum for commercial/industrial
use. All parts used in the manufacturing of this vacuum have passed rigid quality
control standards prior to assembly and an "each unit" fi nal inspection prior to
packaging is your assurance of proper assembly. This vacuum was protectively
packed to prevent possible damage in transit. Should damage occur, please
notify the transporting carrier immediately for loss and/or claim.
Thermal Protection
This appliance is equipped with a self-resetting
thermal protector. Vacuum will shut off if the inlet
is plugged or if the airfl ow is severely restricted.
If this occurs, please allow a few minutes for the
thermal protector to cool and reset itself.
Operation Instructions
1. Place the paper fi lter bag over the fl anged
inlet on the inlet and secure with slide on fi lter
retention device.
2. Make sure fi lter is fi rmly seated in lid.
3. When not in use, store tools as shown below.
CAUTION
Never lubricate the vacuum cleaner motor. The
motor bearings are permanently sealed. This vacuum is
intended for indoor or outdoor use and for wet pickup, but
it is not intended to be exposed to rain.
CAUTION
Do not use this vacuum to pick up hazardous
materials without HEPA fi lter being installed.
Operation & Care Instructions
Save For Future Reference
ABOUT THE MACHINE
WARNING:
 UNPLUG the vacuum when working on the
motor or any electrical part.
 CHECK the condition of all electrical cords
before each use.
 DO NOT lubricate the motor; it is equipped with
sealed bearings.
 The appliance has NO user serviceable parts.
 DO NOT vacuum with a frayed, worn, or
damaged cord.
 DO NOT vacuum liquids or expose the canister
vacuum to rain or water.
 DO NOT vacuum hazardous or toxic materials
without HEPA in place.
 DO NOT use to pick up fl ammable.
Electrical Cord Care
NEVER stretch the cord tightly between the
vacuum and the outlet. A cord that is stretched
or pulled will not function properly and creates a
danger. After vacuuming, unplug the cord and
wind it up loosely. DO NOT wind the cord up by
wrapping around your hand and elbow.
Proper Storage
When the vacuum is not in use, it should be stored
in a dry place.