MetroVac SK-1 Mode D'emploi page 4

***READ ALL INSTRUCTIONS BEFORE USE***
AIR FORCE BLASTER SIDEKICK
Model SK-1
1. Insert the grounded plug of the Power Supply Cord (F) into a grounded three
conductor 16/3 extension cord.
IMPORTANT: PRODUCT MUST BE GROUNDED.
WARNING: IMPROPER CONNECTION OF THE EQUIPMENT GROUNDING
CONDUCTOR CAN RESULT IN A RISK OF ELECTRIC SHOCK!
2. Move your motorcycle to a dry area of the driveway or garage to eliminate risk of
electric shock.
HOLD THE DRYER BY THE HANDLE
3. Start your Blaster Sidekick by pushing the On/Off Switch (B) up for On and down
for Off.
4. The Blower Nozzle (E) and the Air Flare (D) fit directly at the end of the steel tube
to control the air velocity.
PLEASE NOTE:
DUE TO THE TREMENDOUS VELOCITY OF AIR PRODUCED BY THE AIR FORCE
BLASTER SIDEKICK, YOU MAY EXPERIENCE SOME AIR VENTING BY THE SEAMS,
THIS IS COMPLETELY NORMAL AND HELPS KEEP THE UNIT RUNNING
EFFICIENTLY.
FILTER LIFE IS DEPENDENT ON USAGE. CHECK AND REPLACE WHEN
REQUIRED.
CAUTION: DO NOT DROP THIS APPLIANCE. MOTOR MALFUNCTION
CAUSED BY PRODUCT BEING DROPPED IS NOT COVERED UNDER
WARRANTY.
DELIBERATELY MADE BETTER IN THE U.S.A®