English:
Functional 4-Point Knee Orthosis
Patient Application Guide
Indications
· Instabilities and ruptures of ACL, PCL MCL or combined instabilities
· Complex knee instabilities from traumatic or degenerative origin
· Pre- /post-operative treatment of the above mentioned injuries
· Protection of the knee ligaments in sports
Intended use
Apply the device to provide support to the knee joint. This brace allows
the user to perform functional activities with very little restrictions.
Precautions
· Don t apply the straps too tight that it interferes with circulation or that nerves
experience too much compression.
· If unusual swelling, skin discoloration or discomfort occurs, use should be
discontinued and a healthcare professional consulted.
·
In case you have doubts about the application of the product, you should
contact an orthopaedic specialist (doctor or technician).
Application of the brace
1. Open all hook closures, pull the strap through the D-Ring and close the
hook temporarily again by laying it down on the strap
2. Be seated on the edge of a chair with the knee bended for about 45°. Step
with the foot through the brace and move the centre of the joint about 2 cm
above the centre of the patella.
3. Fasten strap 1 (front - shin) and strap 2 (back - thigh)
4. Push the hinges backwards for about 1 cm. Note: these are now positioned
slightly behind the knee, however, when all other straps are firmly closed &
attached, the hinge moves forward and gets in the right position.
5. Fasten straps 3 through 5. Tighten strap 5 firmly !
6. Get in the upright position and tighten strap 6 (in case of PCL injury). Make
a few steps and bend the knee when this is possible or allowed, and re-
tighten straps when necessary for a better fixation or comfort
7. Check whether the aluminium cuffs fit correctly at thigh and calf without
creating excessive pressure. The condylar pads should also ensure a
correct fit of the hinges around the knee. The brace has been delivered with
3 different types of knee pads. These should enable you to adjust the width
of the brace correctly to the width of the knee.
8. Only for technician or doctor: enclosed flexion and extension stops allow
you to determine the patient s knee range of motion. Unscrew the black
hinge cover and place the wedges with correct degrees at the front or back
of the hinge.
Care & Cleaning
Remove the soft fabrics from the stays. Fasten closures and hand-wash with
lukewarm water and mild soap. Rinse thoroughly. Do not wring. Dry at room
temperature and be sure the foam is completely dry before re-applying it.
Clean the metal frame with a wet cloth and dry it afterwards.
Check screws for tight fit regularly and contact an orthopaedic technician in
case parts should be replaced.
Warnings
The product should only be used in case of a medical indication
prescribed by a physician. It should also be applied by a competent
orthopaedic technician. This person has also the responsibility to provide the
patient accurate information about correct and safe use, according its individual
needs.
The patient should under no circumstances make any change or adjustment to
the brace without the consent of physician or orthopaedic technician. (i.e.
application or removal of hinge wedges)
This device is meant for single patient use
Français:
Orthèse de Genou Fonctionnelle 4 Points
Notice - Mode d'emploi
Indications
·
Instabilités et ruptures LCA, LCP, LCM, LCL ou instabilités combinées
·
Instabilité complexe du genou des origines traumatiques ou dégénératives
·
Traitement pré/postopératoire des lésions mentionnées ci-dessus
·
Protection des ligaments lors d activités sportives
Intended use
Apply the device to provide support to the knee joint. This brace allows the
user to perform functional activities with very little restrictions.
Précautions
·
Veuillez ne pas trop serrer les bandes pour ne pas entraver la circulation ou les
nerves.
·
En cas de gonflement anormal, de décoloration anormale de la peau ou de gêne
inhabituelle, nous vous recommandons d interrompre l utilisation de l orthèse et
de consulter un médecin.
·
Si vous avez des questions concernant l utilisation, veuillez-vous adresser au
technicien orthopédiste ou le médecin traitant.
Application
1. Ouvrir tous les bandes, enlever les du boucle et attacher les de nouveau
temporairement sur soi-même.
Positionner le patient avec la jambe fléchis à 45°, mettre l orthèse sur le membre
2.
et positionner le centre des charnières 1 á 2cm au-dessus du centre du genou
Fermer la bande 1 (tibia) et 2 (cuisse).
3.
Pousser les charnières à peu près un centimètre vers le bas. Note : elles sont
4.
positionnées derrière la courbe du genou, car lorsque chaque bande est fermée,
ils bougent vers l avant, jusqu à ce que l attelle soit correctement positionnée sur
la jambe.
Fermer la bande 3 à travers la bande 5. Serrer bande 5 très ferme.
5.
6. Se lever et fermer la bande numéro 6 (en cas des blessures LCP). Demander au
patient de marcher quelques pas et de plier la jambe quand il est possible, et
finalement resserrer les sangles lorsque cela est nécessaire pour une meilleure
fixation ou confort.
7. Vérifier que les manchettes de la cuisse et du mollet enroulent bien les contours
des muscles, et que les muscles ne subissent pas trop de pression. L'orthèse a
été livrée avec 3 différentes types de rembourrages. Ils devraient vous permettre
d'ajuster la largeur de l'orthèse correctement à la largeur du genou.
8. Uniquement pour le médecin ou le technicien : les arrêts de flexion et
d'extension vous permettent de déterminer l'amplitude du genou du patient.
Dévisser le couvercle noir de la charnière et placer les cales avec degrés
corrects à l'avant ou à l'arrière de la charnière.
Entretien
Enlever la mousse des barres. Ensuite fermer les attaches et laver à la main, à l eau
tiède à l aide d un savon doux. Rincer abondamment. Ne pas essorer. Laisser
sécher à température ambiante. S assurer que la mousse soit parfaitement sèche
avant d utiliser l orthèse de nouveau
Nettoyez l'armature avec un chiffon humide et séchez-le ensuite. Vérifiez les vis
régulièrement pour qu ils soient serrés. S adresser à un technicien orthopédique
dans les cas où certains composants doivent être remplacés.
or
when
Avertissements
L utilisation de ce produit est réservée aux indications médicales ou sur ordonnance
médicale. Le réglage individuel doit être effectué par un technicien orthopédiste. Ce
dernier est un interlocuteur compétent aussi bien en ce qui concerne l usage que
pour donner des informations concernant la sécurité d utilisation.
Des réglages ou modifications éventuelles ne doivent être effectuées que sur
prescription médicale et doivent être exécutées par un technicien orthopédiste.
Les réglages effectués par le médecin ou le technicien orthopédique, ne doivent
surtout pas être modifiés.
Le produit est prévu pour être utilisé par un seul patient.
Deutsch:
Funktionelle 4-Punkt Knieorthese
Bedienungsanleitung
Anwendungsgebiete:
·
Instabilitäten und Rupturen des LCA, LCP, LCM, LCL
·
Komplexe Knieinstabilitäten von traumatischer oder degenerativer Art.
·
Prä- oder postoperative Behandlung, rehabilitativ oder konservativ, der
genannten Verletzungen
·
Schutz der Kniebänder im Sport
Intended use
Apply the device to provide support to the knee joint. This brace allows the user
to perform functional activities with very little restrictions.
Vorsichtsmassnahmen
·
Die Knieorthese darf nicht so eng anliegen, dass dadurch die Blutzirkulation
beeinträchtigt oder Nerven eingeklemmt werden
·
Falls es zu ungewöhnlichen Schwellungen, Hautverfärbungen oder einem
unangenehmen Tragegefühl kommt, sollte die Anwendung unterbrochen und ein
Arzt oder Orthopädietechniker kontaktiert werden.
·
Wenden Sie sich bei Zweifeln über die Art der Anwendung bitte an Ihren Arzt
oder Orthopädietechniker.
Anwendung
1. Alle Klettriemen öffnen, sie aus den jeweiligen Schnallen ziehen und
provisorisch wieder um sich selbst verschließen.
2. Das Knie bei sitzender Position um etwa 45° beugen. Die Knieorthese am Bein
anbringen und die Mitte des Gelenks etwa 1 2 cm über der Mitte der Patella
ansetzen.
3.
Riemen Nr. 1 und Nr. 2 zuerst schließen
4. Die Gelenke um ca. 1 cm nach unten drücken. Anm.: Die Gelenke werden
hinter dem gebeugten Knie angebracht, da sich diese mit dem Verschließen jedes
Riemens nach vorne verschieben, bis die Orthese in der richtigen
Position am Bein angebracht ist.
5.
Die Riemen Nr. 3 bis Nr. 5 in der Reihenfolge der Nummern schließen
6.
Aufstehen und Riemen Nr. 6 schließen (bei PCL-Verletzung). Kurz gehen und
die Knie einige Male beugen. Bei Bedarf für eine bessere Fixierung die Riemen
wieder öffnen und festziehen
7.
Überprüfen, dass die Kondylenstützen gut am Gelenk anliegen und dass die
Oberschenkel- und Beinmanschetten gut am Muskel anliegen, ohne jedoch
einen übermäßigen Druck auszuüben. Der Orthese wurde mit 3 verschiedenen
Kondylenpolster ausgeliefert. Damit kann die Orthese korrekt auf die Breite des
Knies angepasst werden.
Pflege & Reinigung
Die Schaumstoffpolster von den Aluschienen entfernen. Alle Klettverschlüsse
schließen. Handwäsche in lauwarmem Wasser mit Neutralseife. Gründlich
auswaschen. Nicht auswringen. Bei Raumtemperatur trocknen lassen und dafür
sorgen, dass der Stoff vollkommen trocken ist, bevor die Schiene wieder angelegt
wird
Den Rahmen mit einem Schwamm mit lauwarmen Wasser und Neutralseife
reinigen. Mit einem Tuch trocken reiben
Überprüfen Sie regelmäßig ob alle Schrauben noch korrekt sitzen. Kontaktieren
Sie einen Orthopädietechniker falls Teile ersetzt werden müssen.
Hinweis
Die Knieorthese muss bei Beginn der Anwendung durch einen Arzt oder
Orthopädietechniker angepasst werden.
Das Produkt darf nur bei medizinischer
Indikation oder auf ärztliche Anordnung verwendet werden. Es muss von einem
Orthopädietechniker angelegt werden, der sowohl für das Anlegen wie auch für die
Informationen über den sicheren Gebrauch entsprechend Ihren persönlichen
Anforderungen Ihr kompetenter Ansprechpartner ist.
Die Wirksamkeit, Verträglichkeit und die Funktionalität des Produktes sind nur dann
garantiert, wenn es immer mit größter Sorgfalt angelegt wird. Jede eventuelle
Änderung der Struktur oder der Einstellung muss von einem Arzt verordnet und von
einem Orthopädietechniker ausgeführt werden. Die Einstellung, die der
Arzt/Orthopädietechniker vorgenommen hat, darf absolut nicht verändert werden.
Es wird empfohlen, dass das Produkt immer nur von einem Patienten verwendet wird.