Leatt Fusion 3.0 Mode D'emploi page 4

Fitment and Adjusting
1. Waist belt
1a.
Open the waist belt on both sides.
2. Neck Brace
2a. 2b.
Next open the neck brace by pushing the release button (1a) on the sides of the
brace (2b) and pull the brace shoulder appart (2c).
3. Shoulders
3a.
3b.
Locate the shoulder straps under the shoulder cups (3a) and pull the upper
strap away from the bottom strap (3b), reattach in right position
5
1b.
2c.
Copyright © 2014, Leatt ® Corporation
4. Fit
4a.
front
Put the protector on, make sure the it is the right side around front to front (4a)
and back to back (4b). Go through steps 1- 3 in reverse to close everything up.
5. Fitment check
5a.
Be sure to check that the brace shoulder sits directly over your shoulder.
Back
5b.
Front
Use help to measure from the bottom of the helmet rim to the top of the neck brace
platform (5b). The zone of optimum effectiveness is between 50 - 80 mm in Front
and 50 - 90 mm in Back (5c).
Copyright © 2014, Leatt ® Corporation
4b.
back
Back
Front
5c.
90 mm
50 mm
80 mm
50 mm
6