Kit Contents
• 1 GV60 outdoor receiver with conformal coating—
to resist weather—part no. 4005111
• 1 Overlay conversion label—part no. 4006081
• 1 Outdoor Lighting Instructions card—part no.
4005169
Replace the existing receiver
Locate the existing receiver on the appliance. The
receiver is held in place by Velcro on most appliances.
Refer to the appliance's manual if necessary.
1. Detach the receiver and pull it out of the appliance
to disconnect it. Be careful not to pull too hard as
you could damage the wire connections, particularly
the ignition wire connection.
2. Label all wires using the diagram below.
3. Remove all the wires connected to the receiver and
set the receiver aside.
4. Connect the outdoor receiver (G6R-R3AMC) to the
existing wiring. DO NOT INSTALL BATTERIES YET!
Ensure no batteries are installed in the RBWSK
if used. Connections on the outdoor receiver are
identical to the existing receiver. See diagram below.
Caution
DO NOT PUT BATTERIES IN THE REMOTE
CONTROL RECEIVER OR RBWSK until the wires
are connected to the burner control unit as
short-circuit could result in the destruction of the
electrical components.
Take the switch wire and plug it into the receiver's
connection slot as indicated.
IMPORTANT
The connection can
only be done one
way. Do not force it or
damage the pins on
the receiver box!
Caution
To avoid short-circuit to the receiver,
position the antenna so that it DOES
NOT TOUCH the ignition wire.
5. Install and connect the wall switch supplied with
the appliance to the receiver following instructions
provided with the appliance's installation manual;
if the appliance is not supplied with a wall switch,
connect the RBWSK—Remote battery and wall
switch kit (supplied separately) to the outdoor
receiver—see installation instructions supplied
with the kit.
2
G6R-R3AMC—
Outdoor receiver
6. Insert 4 AA alkaline batteries into the outdoor
receiver or the RBWSK kit only after all connections
are completed.
Caution
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the receiver
or the handset! This could cause a short circuit to
the receiver.
7. Test the operation of the wall switch—see
appliance's or wall switch kit instructions manual.
Wall Switch
Harness
Valve Wire
Harness
Red
Yellow
Ignition Wire Connection
(spade type connector)
Be careful when removing and
reinstallaing: not to bend or
break the spade connector
Conversion label and
Lighting Instructions
RBWSK— Remote
Battery Wall
Switch kit power
connector
Ignition
Wire
Antenna