Publicité
Les langues disponibles
Les langues disponibles
•
Replace the Height Adjustment Collar on top of the Inner Tube. Pull the
Inner Tube out from the Outer Tube to adjust the tube to the desired
height and tighten the collar.
•
If necessary, slightly loosen the Set Screw by turning it counterclockwise.
Slide the Switch Panel down over the Inner Tube and tighten the Set
Screw. Make sure the Set Screw is tightly secured.
•
Position the Rear Grille against the front of the Motor Housing with the
handle uppermost, ensuring that the locating pegs on the Motor Housing
are engaged correctly in the holes of the Rear Grille.
•
Tighten the Rear Grille Mounting Nut clockwise. DO NOT OVERTIGHTEN.
•
Push the fan blade onto the Motor Shaft, locating the slot at the back of
the blade on the drive pin that passes through the Motor Shaft.
•
Tighten the Blade Cap by turning it counterclockwise.
•
Position the Front Grille against the Rear Grille so that the holes in the
rims that accept the small Nut and Bolt are in line. Insert the bolt
through the holes and screw on the nut. Do not fully tighten at this stage.
•
Fully tighten the small Nut and Bolt that passes through the rim of the
grille.
To Use
CAUTION: Ensure the product is fully assembled before plugging it into an
outlet. And place your fan on a level and dry surface.
NOTICE: To avoid damaging the product, press only one Button at a time.
1. Place the assembled Fan on a flat, level, stable surface and ensure it is
set to "0", means OFF.
2. Plug the Power Cord into a standard 120V AC, 60Hz electrical outlet.
3. To turn on, press the desired Speed switch: "1,2,3" means LOW, MID, or
HIGH.
4. To adjust the angle, tilt the Motor Housing up or down until it clicks into
place where desired.
5. To adjust the height, loosen the Height Adjustment Knob, raise or lower
the Extension Pole as desired, and retighten the Height Adjustment Knob.
6. To start/stop oscillation, push/pull the Oscillation Knob, respectively.
7. To turn off, press the switch to "0" speed, and then unplug the product
from the outlet.
WARNING: Always unplug the product from the outlet when not in use or
if it will be left unattended.
WARNING: Always ensure the product is unplugged from the electrical
User Servicing Instructions
4
Publicité
