LG LN52 Serie Manuel D'utilisation page 30

8
SAFETY INSTRUCTIONS
y Please follow the installation instructions below to prevent the product from
y
Otherwise, this may result in fire.
y Take care not to touch the ventilation openings when watching the TV for
y
y Periodically examine the cord of your appliance, and if its appearance indicates damage or
y
deterioration, unplug it, discontinue use of the appliance, and have the cord replaced with an
exact replacement part by an authorized servicer.
y Prevent dust collecting on the power plug pins or outlet.
y
y Protect the power cord from physical or mechanical abuse, such as being
y
y Do not press strongly upon the panel with a hand or sharp object such
y
y Avoid touching the screen or holding your finger(s) against it for long
y
y When cleaning the product and its components, unplug the power first and
y
y As long as this unit is connected to the AC wall outlet, it is not disconnected from the AC power
y
source even if you turn off this unit by SWITCH.
y When unplugging the cable, grab the plug and unplug it, by pulling at the
y
y When moving the product, make sure you turn the power off first. Then,
y
overheating.
- The distance between the product and the wall should be more than
y
10 cm.
- Do not install the product in a place with no ventilation (e.g., on a
y
bookshelf or in a cupboard).
- Do not install the product on a carpet or cushion.
y
- Make sure the air vent is not blocked by a tablecloth or curtain.
y
long periods as the ventilation openings may become hot. This does not
affect the operation or performance of the product.
This may cause a fire hazard.
twisted, kinked, pinched, closed in a door, or walked upon. Pay particular
attention to plugs, wall outlets, and the point where the cord exits the
appliance.
as nail, pencil or pen, or make a scratch on it, as it may cause damage to
screen.
periods of time. Doing so may produce some temporary or permanent
distortion/damage to screen.
wipe it with a soft cloth. Applying excessive force may cause scratches or
discolouration. Do not spray with water or wipe with a wet cloth. Never use
glass cleaner, car or industrial shiner, abrasives or wax, benzene, alcohol
etc., which can damage the product and its panel.
Otherwise, this may result in fire, electric shock or product damage
(deformation, corrosion or breakage).
plug. Don't pull at the cord to unplug the power cord from the power board,
as this could be hazardous.
unplug the power cables, antenna cables and all connecting cables.
The TV set or power cord may be damaged, which may create a fire hazard
or cause electric shock.