Publicité
Les langues disponibles
Les langues disponibles
Operating instructions
Gaming headset RF-GHD-100
Item no. 1574530
Intended use
The product is used as a headset with voice function and is suitable for connection to
smartphones, game consoles, computers, or other audio devices with a 3.5 mm audio jack.
With the in-line controller the volume can be regulated and the microphone can be switched
on and off.
This product is intended for indoor use only. Do not use it outdoors. Contact with moisture (e.g.
in bathrooms) must be avoided under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify this product. Using the
product for purposes other than those described above may damage the product. In addition,
improper use can cause hazards such as short circuits or fire. Read the instructions carefully
and store them in a safe place. Make this product available to third parties only together with
its operating instructions.
This product complies with statutory national and European regulations. All company and
product names are trademarks of their respective owners. All rights reserved.
Delivery content
• Headset
• Operating instructions
Up-to-date operating instructions
Download the latest operating instructions at www.conrad.com/downloads or scan the QR code
on this page. Follow the instructions on the website.
Safety instructions
Read the operating instructions and safety information carefully. If you do
not follow the safety instructions and information on proper handling in this
manual, we will assume no liability for any resulting personal injury or damage
to property. Such cases will invalidate the warranty/guarantee.
a) General information
• The product is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become
dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, stop using it and prevent
unauthorized use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Always handle the product carefully. Jolts, impacts or a fall even from a low height
may damage the product.
• Always observe the safety and operating instructions of any other devices which
are connected to the product.
• Do not listen to music at an excessive volume for prolonged periods. This may
damage your hearing.
• Consult a technician if you are not sure how to use or connect the product.
• Maintenance, modifications and repairs are to be performed exclusively by an
expert or at a qualified shop.
• If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
Product overview
Operation
To avoid distortion or mismatching which could damage the headset or the connected
device, the product may only be connected to suitable 3.5 mm headphone outputs.
Refer to the connection information in the "Technical data". If your audio device does
not have a suitable jack for connection of the headphone, please use a suitable
adapter.
• Turn down the volume of the headset output completely on the device to be connected.
• Plug the 3.5 mm headset jack plug into the corresponding socket on your device.
• The ear cups can be adjusted by pulling down or pushing up. The ear cups are labelled on
the outside with R and L.
• Adjust the volume on your smartphone/audio device and then adjust the volume using the
"VOLUME" control on the headset cable.
• Fold out the microphone to the front and set the microphone switch ON MIC OFF to ON,
to use the microphone and make calls. Set the microphone switch to OFF, to switch the
microphone off.
Care and cleaning
• Before cleaning, disconnect the product from the connected device.
• Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these may
damage the casing or cause the product to malfunction.
• Use a dry, lint-free cloth to clean the product.
Disposal
Electronic devices are recyclable waste and must not be placed in household waste.
Always dispose of the product according to the relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the
environment.
Technical data
a) General information
Connection ................................... 3.5 mm jack plug, 4-pin
Cable length ................................. 1.25 m
Operating/storage conditions ........ -10 °C to +45 °C, 35% to 80% RH
Dimensions (W x H x D) ............... 200 x 90 x 180 mm
Weight .......................................... approx. 243 g
b) Headphones
Frequency range .......................... 20 – 20000 Hz
Sensitivity ..................................... 108 dB
Impedance .................................... 32 Ω +/-10%
Driver unit Ø ................................. 40 mm
c) Microphone
Type .............................................. Electret condenser
Sensitivity ..................................... -42 +/- 3 dB
Frequency range .......................... 100 – 10000 Hz
Directional characteristic .............. omnidirectional (sphere)
Impedance .................................... 2.2 kΩ
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming, or the capture in
electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited.
This publication represents the technical status at the time of printing.
Copyright 2017 by Conrad Electronic SE.
*1574530_v1_1017_02_hk_m_en
Publicité
