Assembly - Jetboil HALFGEN Instructions

ASSEMBLY

WARNING
• Perform leak checks outside, in a well-ventilated area.
• Operate at least 1m/3.3ft away from combustible materials and
ignition sources.
• Before each use: Keep stove area clear and free from combustible
materials, gasoline, and other flammable vapors and liquids.
• Do not obstruct the flow of combustion and ventilation air to the stove.
• Do not use windscreen other than the one provided with this product;
use of another windscreen or outback oven can overheat the fuel
canister, resulting in explosion.
• Do not use an appliance which is leaking, damaged or which does not
operate properly.
• Always change gas canisters in a well ventilated location away from
any sources of ignition, such as naked flames, pilot, electric heaters/
equipment and away from other people.
• Do not install or use Fuel Cylinder in an inverted position
(Reference Fig. 4).
7
1. Remove packed contents from bag (Fig. 1)
2. Place latched stove on a flat, level surface, at least 1m/3.3ft away
from any combustible materials or ignition sources.
3. Pull Rubber Latches (2.1) free from latch hub (2.2)
4. Remove the 9" FryPan (1.1) and set to the side
5. Perform LEAK CHECK PROCEDURE (see pg. 4) before proceeding.
6. Ensure that control valve (3.1) is closed firmly (rotate clockwise).
7. Check that Gasket (4.4) at Fuel Input connection (4.2) is in place and
in good condition before connecting to the Regulator.
WARNING Do not use the appliance if it has damaged or worn seals;
this may result in gas leakage.
8. To check that the gas canister is not empty, liquid fuel may be heard
and/or felt inside when the canister is shaken.
9. Connect Fuel Regulator (4.1) to the Fuel Input port (4.2)
located in the rear of the left side of the stove by threading
Coupling clockwise.
10. Connect Propane Cylinder (4.3) (sold separately) into Fuel regulator (4.1)
by threading clockwise in the orientation shown in Fig. 4.
WARNING Do not install or use Fuel Cylinder in an inverted position.
11. To attach Windscreen (1.2), align the large opening in the Windscreen
arms over the three Feet (5.1) located on the bottom of the stove, and
pull outward until the smaller opening (5.2) slides into the slots (5.3)
on each of the three feet.
NOTICE Prior to initial use, remove plastic backing on both sides
of the Windscreen.
NOTICE Ensure a 1" minimum gap between Windscreen and any
cookware used when Windscreen is attached.
8