Publicité
Les langues disponibles
Les langues disponibles
Fixing the unit to the COP
Follow the simple steps below to install the surface mounted COP accessory on the COP.
1. Cut holes in COP for
accessory cables
4. Fix unit in place with four
screws provided
Programming Options
+
One touch programming (programming tool)
+
Programming through the full product menu (programming tool)
+
Remotely via ETR software or a touch-tone telephone handset
Programming, at the touch of a button
1.
Plug the programming tool into the C100 unit
2.
If the C100 programming unit has a programming template set up,
the following message will appear 'One-touch programming?'
3.
Press the
button and the programming will be downloaded to
the C100 unit automatically
If a location message needs to be recorded on the unit, press 1 to go into
programming mode and record the message in the following location on the
programming menu Messages> Location.
Programming is now complete. You need only refer to the below sections of
the guide if more advanced programming is required.
2. Drill fixing holes
5. Insert tongue of SS plate
in the groove at the top of
the plastic housing
3. Feed the cable through
the holes
6. Secure SS plate using
security screw provided
Publicité
