Led Feedback; Trip Output - Control Techniques Emerson Digistart CS Guide D'utilisation

5.

LED Feedback

Figure 5-1 Feedback LEDs
6.

Trip Output

When an input activates, the associated LED flashes and the trip output changes state. The soft starter will trip on network
communications failure. To resume normal operation, the soft starter must be reset.
The module's trip output will also change state to indicate any other trip on the soft starter.
Pump Application Module User Guide
Issue 1
The four LEDs on the front of the module indicate the state of each input.
LED
Low pressure
High pressure
Low water
PT100
www.controltechniques.com
On = Input closed
Off = Input open
Flashing = Tripped
On = PT100 connection healthy
Off = PT100 input disabled
Flashing = Tripped
Function
7