Publicité
i. Replace XS back cover.
XS712 – Fig. 14
XS715 – Fig. 27
XS717 – Fig. 39
XS719 – Fig. 51
j. Optional Dvd-Rom – Plug the connector
and mount the cover.
XS712 – Fig. 15
For wiring to the board's connectors
consult maker's guide
Substituting the battery
a. Switch off XS.
b. Remove back cover (see points b. c. d.
- Inserting the PCI/PCIe board).
c. Replace the battery on the motherboard
(see motherboard manual).
ATTENTION: Insert the new battery
checking that the polarities are correct.
Discarded batteries should be placed in
appropriate containers.
d. Replace back cover (see points i. j. -
Inserting the PCI/PCIe board).
Power supply
Fig. 52 - Power connector pin-out.
Fig. 53 - Recommended power
connection.
Fig. 54 - Warning: These two
configuration will seriously damage
components
IMPORTANT:
The
devices connected to the serial
and/or parallel communication ports
MUST have the same potential as the
0V supply of the XS. The circulation
of current between the 0V supply
and the earth of the communication
ports could cause damage to certain
components of the XS or of the
devices connected to it.
Working temperature
0 / +50°C
All manuals and user guides at all-guides.com
earth
of
the
Electromagnetic compatibility
Restriction of use: protection
requirements are not ensured in
residential areas.
Communication ports
Refer to motherboard documentation
for connection of link to peripheral
devices.
Cleaning
For cleaning the XS we recommend
Denaturalised Ethyl Alcohol.
Certifications
All the products described in this
manual comply with the following
standards:
electromagnetic compatibility (EMC):
!
emissions EN 61000-6-4 (2007)
!
immunity EN 61000-6-2 (2005)
and thus are in line with:
Council Directive
EMC 2004/108/EC
Publicité
