Publicité
Les langues disponibles
Les langues disponibles
PROBLEM
Very little steam or no
steam comes out.
The device does not
switch on.
DISPOSAL OF MATERIALS
A symbol of a crossed-out wheeled bin means you
should not dispose of electrical devices as unsorted
municipal solid waste.
Take them to a separate collection station.
Contact the local authorities to obtain more informa-
tion about available waste collection systems.
If electrical devices are dumped in landfills, the toxic
substances they contain may filter into the soil and en-
ter the food chain, thus damaging human health and
well-being.
When replacing an old appliance with a new one, it is
mandatory for the distributor to pick up the old one and
dispose of it at no extra charge
Quality Warranty:
This product is covered by a warranty against manu-
facturing defects subject to the time periods stipulated
by the legislation in force in each country.
This warranty does not cover damages resulting from
inadequate use, negligent commercial use, abnormal
wear and tear, accidents or improper handling.
Australia & New Zealand only
This product has the benefit of certain Consumer Gua-
rantees. These are prescribed by the Australian Con-
sumer Law & the New Zealand Consumer Guarantees
Act 1993 both of which provide protection for consu-
mers. There is no express warranty for this product
in Australia or New Zealand. The above paragraph
refers to other countries.
DOUBLE INSULATION
This appliance is double insulated; therefore,
no earth wire is required. Always check that the
mains voltage corresponds to the voltage on the pro-
duct rating plate.
This symbol indicates that the surface may
heat up during use.
Made in China
POSSIBLE CAUSE
The water tank could be empty.
The nozzle where the steam comes
out could be blocked.
The device may not be plugged in.
The steam control knob is set to the
minimum level.
A fuse has blown or the circuit
breaker has tripped.
The power cable is not plugged in.
The internal fuse has blown.
POSSIBLE SOLUTION
Fill the tank with water.
Clean the nozzle where the steam
comes out.
Make sure the device is plugged in.
Turn the steam control knob clockwise.
Replace the fuse or reset the circuit
breaker.
Plug the power cable into the mains
Contact the customer service de-
partment.
Publicité
