Gewiss SYSTEM Serie Mode D'emploi page 16

ATTENTION IMPORTANT
• Thank you for selecting this Gewiss product.
Gewiss products have been designed with attention to detail and built using only the
very best materials. Gewiss products will guarantee excellent and lasting performance.
• The installer is kindly requested to fill out this leaflet and then hand it to the end user,
asking that he/she carefully read it.
• Carefully read the instructions below as they provide important information on how the
gas detector works, how it should be fitted and serviced (routine and extraordinary
maintenance) and what to do with it once it reaches the end of its expected life.
• The manufacturer may not be held liable for injury to persons or pets or damage caused
by the use of the gas detector in situations and conditions other than those indicated in
the instructions below.
• The manufacturer may not be held liable in the case that the detector is sold in non-
original packaging. Immediately after removing the product from its packaging, make
sure that it is not damaged.
• Make sure that the main power supply has been switched off before attempting to fit
the device or touch the wiring.
• The gas detector will only work when plugged in to the mains. A device has a one minute
delay after a blackout or during installation, during which time its electronic components
are reset (see how it works - page 26).
• The sensor reaches full efficiency after 10 days from plugging in.
• Check that the detector is suitable for the type of gas it is expected to detect.
• Before connecting the detector, make sure that the data on its ratings plate match the
mains supply.
• Connect the detector as indicated in the drawings on page 23.
• All System-Playbus products must be fitted in compliance with HD 384 - IEC 364
standards for domestic appliances and similar devices, in dust-free areas and where
there is no need for special water-proofing protection.
• Always contact an authorised technician or Gewiss's own customer service ("SAT" - see
page 82) if the detector is faulty and/or malfunctions and in the case of extraordinary
maintenance and scrapping.
16