Cooke & Lewis EQUINOX Guide Rapide page 4

Safety
For domestic use only.
CAUTION: Not suitable for use in conjunction
with instantaneous water heaters (e.g.
an instantaneous water heater without
modulation and without water tank)
CAUTION:
otherwise it may damage the product.
Care should be taken when drilling into walls
to avoid any hidden pipes or wires.
When drilling through ceramic tiles use a
specialist drill bit.
Where possible drill between tiles in the grout.
CAUTION: Always ensure the product is
securely installed before use.
When the installation is complete, turn the
water supply on and check for leaks on
connection points.
Failure to follow these instructions may result
in personal injury, damage to the product and
property damage.
Prevention of frost damage.
When the domestic water system is drained,
since non-return valves are installed in the hot
and cold water connections. For this purpose,
Always be aware of the danger of scalding
from hot water. Ensure users are aware of
temperature stop has been adjusted.
Never twist or kink the hose or otherwise
Getting started...
Check to make sure you have all of the parts
listed.
When you are ready to start, make sure you
have the right tools to hand, plenty of space
and a dry area for assembly.
Ensure the mounting surface is sound, clean,
dry and level before this full system is installed.
Please note: The wall plugs included with
this product are suitable for solid walls only.
Plasterboard or stud walls may require
are correct for the wall type.)
It is important to that both supply pipes are
ensure no pipe/plumbing debris enters the
TURN OFF WATER MAINS SUPPLY. The
mains stopcock is usually situated where the
supply enters the building.
It is also recommended that the water heating
arrangements are turned off.
Isolate the hot and cold water supply.
Minimum 0.1
This product is suitable for high water
pressure systems.
hot temperature setting of the valve.
should be no more than 2 bars. If this limit is
supplied).
Operating pressures on hot and cold lines
should be kept as even as possible in order to
pressure reducing valve (not supplied) must
into the wall unions, if available, to reduce
water consumption on high pressure systems.
Each shower valve is supplied with integral
non return valves in the hot and cold inlet
contamination of the water supplies.
The safety stop limits the temperature range
by pressing the safety stop button and this
temperature can be preset during installation.
In more detail...
The 3 golden rules for care
Use warm soapy water and a soft damp cloth
to clean the surface of the product. Wipe dry
with a clean cloth.
Never use any solvents, scourers, abrasives,
bleach, acids, strong detergents, aggressive
chemical cleaners or solvent-type cleaning
solutions on the product.
security and tightness at regular intervals.
Warranty Period and Conditions
Guarantee related queries should be addressed
purchased the product from.
This guarantee is in addition to and does not
affect your statutory rights.
At Cooke & Lewis, we devote special attention
to selecting high-quality materials and use
manufacturing techniques that enable us to create
designer and durable product ranges.
product manufacturing defects.
the date of purchase, for normal, non-professional
household use. The warranty shall only apply
upon presentation of the till receipt or the invoice.
Keep your proof of purchase in a safe place.
The warranty covers product breakdowns and
malfunctions under the condition that the product
is used in accordance with its intended use
and subject to installation and maintenance
in accordance with good practice and the
information contained in the user's manual.
This product must be installed so that it may be
later removed without damaging it.
This contractual warranty does not cover defects
and damage caused by the natural wear of
freezing, damage caused by water quality
(hardness, aggressiveness, corrosion, etc.), by
the presence of foreign bodies transported by
lack of room ventilation, and damages that could
be the consequence of improper use, misuse,
negligence, accident or maintenance that is
defective or does not comply with good practice or
the information in the user's manual.
of accessories and/or non-original equipment
manufacturer or improper replacement parts,
The warranty is limited to those parts recognised
as defective. Under no circumstances shall it
and consequential damage.
IMPORTANT
RETAIN THIS
INFORMATION
FOR FUTURE
REFERENCE:
READ CAREFULLY
Sécurité
Utilisation domestique uniquement.
ATTENTION : Ne convient pas pour une
utilisation avec une production d'eau chaude
instantané sans modulation et sans ballon
cumulus)
ATTENTION :
produit .
Des précautions doivent être prises lors des
Lors de perçages dans des carrelages en
céramique, utilisez un foret spécial.
Dans la mesure du possible, percez dans les
joints de ciment entre les carrelages.
ATTENTION : Assurez-vous toujours que
le produit est correctement installé avant de
l'utiliser.
Lorsque l'installation est terminée, ouvrez
ne présentent pas de fuites.
Le non-respect de ces consignes peut
entraîner des blessures, des dommages au
produit et des dommages matériels.
Prévention des dommages dus au gel.
Quand le système d'eau domestique est
purgé, les mitigeurs thermostatiques doivent
être purgés séparément, car des clapets de
non-retour sont installés dans les raccords
d'eau chaude et d'eau froide. A cet effet, le
mitigeur doit être retiré du mur.
Soyez toujours conscient du danger de
brûlure par eau chaude. Assurez-vous que les
utilisateurs sont informés de la température
a été ajusté.
Ne tordez ni ne pliez jamais le tuyau. Cela
réduirait le débit d'eau en cours d'utilisation.
Pour bien commencer...