Hanhart Pioneer Série Mode D'emploi Et Garantie page 5

date display indicates one day before the
current date. Warning: Do not adjust the
date between 8 p.m. and 2 a.m. This could
result in damage to the movement.
2. Set the crown to position "III". Rotate the
hands in the anticlockwise direction until
the date jumps ahead of the current day
(midnight). Set the watch to the desired time
of day by continuing to rotate the hands in an
anticlockwise direction.
3. The movement is stopped with the crown
in position "III". To synchronize your
chronograph with an accurate time source
(e.g. a radio-controlled clock), stop the
watch when the seconds hand is at "60".You
can now set the watch to the accurate time.
To restart the movement, push the crown back
into position "I". Do not forget to push back
the crown into position "I" again once you have
completed all the adjustments. The water-
resistance of your chronograph can only be
guaranteed when the crown is at this position.
8
Using the chronograph function
Simple time recording,
single-button watch model
Crown in position"I"
1 START
STOP Read the time
2
RESET TO ZERO
3
If you would like to record a time with your
Hanhart chronograph, the red button "A" is
used for the start and stop functions as well as
to reset the chronograph after a measurement.
You start a time recording by pressing the
red button "A". You stop the time recording
by pressing the red button "A" a second time.
The centre seconds hand and the chronograph
minutes counter display (at 3 o'clock) are used
to read the stopped time. Press the red button
"A" a third time to reset the hands to zero.
9