Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CONVERSION
Conversion to Propane (LP) / Natural Gas
Instructions
are
for
conversion from
connecting
the
unit
to the gas
Units are shipped from the factory
the conversion. If you have model set up for LP, you will need #44, 43 or 41 Natural Gas orifices.
1) Remove trivets, burners and replace valve orifice fittings with those marked
41
for Natural Gas). Reinstall burners and trivets.
2) Before installing regulator, remove regulator cap and flip plastic insert attached to the underside of cap.
Remove
the knobs and
front panel.
Unscrew hexagonal
top
of
regulator.
Natural
Gas to
supply.
equipped
for use on natural gas. Either #53 or 54 orifices for LP (propane) are required for
valve, then remove
Remove plastic insert, flip
over and snap
cap
on
Propane
(L.P.) or vice-versa. The conversion
Unscrew
bolts and pilot
manifold.
back in place.
Page 9
must
be completed
#53 or 54
(for LP (propane) or
Note
number
on
side
of
Orifice fittings
#43=NAT #53=LP
(Typical Sizing)
Swap
fittings
LP
Position
of insert.
Replace
hexagonal
and
tighten.
before
#44, 43 or
valve
cap
Publicité
Chapitres
Table des Matières
Dépannage
