Publicité
Les langues disponibles
Les langues disponibles
INFANT CAR SEAT
INFANT CAR SEAT ATTACHMENT
WITH CHILD TRAY ONLY
• Put the stroller seat in the most
13)
upright position (Fig. 11b).
that the front child tray is firmly
attached to the stroller armrests.
Ensure to remove the Tray Insert
(Refer to Step 3).
• Buckle the support strap located
on the back side of the stroller seat
frame. Tighten until the stroller seat
is fully upright (Fig. 13a).
• Position the infant car seat so that it
faces toward the rear of the stroller.
Push the car seat into the front tray
until it latches into place (Fig. 13b).
Strap both short clips over the infant
car seat through the seat belt slots
on the infant car seat and pull the
strap adjuster tight (Fig. 13c).
• To remove the Infant Car Seat,
unbuckle the secure strap
(Fig. 13a) and remove the short
clips (Fig.13c). Squeeze the release
handle located at the Top-rear of the
seat and carefully lift upward on the
seat (Fig. 13d).
• To remove other Baby Trend® Infant
Car Seats, squeeze the release
handle located at the foot-end of the
seat and carefully lift upward on the
seat (Fig 13e).
NOTE: When not using the car seat,
always store all straps and short clip
/ short clips into the storage pocket
attached to the side of the seat
(Fig 13f).
13
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Check
Fig. 13a
Fig. 13b
Pull
Fig.13c
Pull
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
INFANT CAR SEAT
Other Baby Trend ® Car Seats
Fig. 13d
Storage Pocket
Fig. 13f
Fig. 13e
14
Publicité
