Baby Trend HC01 Serie Manuel D'instruction page 5

ASSEMBLY
9) • Attach each of the Casters to the high
chair leg (Fig. 9). Snap casters into
Bottom of the leg. Check that all four
Casters are securely fastened to the
High Chair.
10) • Flip over Tray to attach Crotch Retainer.
The molded plastic housing must be
oriented by facing the slot toward front
of the Tray. Insert the 4 (3.5mm X 10)
Screws and tighten (Fig. 10).
DO NOT OVER-TIGHTEN.
TO ATTACH SEAT PAD
NOTE: Certain High Chair models are
packaged with the High Chair Seat Pad and
Seat Insert already attached to the Seat Back.
If your model has a Seat Pad and Seat Insert
on the Seat Back please skip ahead to Step 15.
11) • Thread non-buckle end of Harness
Straps called Harness Attachment
Tabs through the provided slots in
the Seat Fabric, Seat Insert, Seat
Back, and Seat Base (Fig. 11). When
Harness Attachment Tabs are through
the provided slots, rotate the Harness
Attachment Tabs 90 degrees. Make sure
that the straps are firmly in place.
7
Copyright © 2015, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
12)
Fig. 9
13)
Fig. 10
OPTIONAL SEAT INSERT
14)
TO REMOVE SEAT PAD
Reverse steps above.
Fig. 11
• Loop the flap on the back of the pad
over the top of the Seat Back. Connect
the Seat Pad to the Seat Back with the
two Elastic Loops. These fit over the
Attachment Tabs located near the top
harness slots (Fig. 12).
• Attach the bottom of Seat Pad to the
Seat Base with the two Elastic loops
located at the rear of the bottom of the
Seat Pad. These fit over the Attachment
Tabs located on the Seat Base near
where the Seat Back and Seat Base
Join (Fig. 13).
• Set Seat Insert onto Seat Pad.
Copyright © 2015, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 12
Fig. 13
8