Inoksan BYM042 Mode D'emploi page 12

WARNING; In order not to damage the
electrical equipment, clean the device with a
direct or high pressured water.
11.PERIODIC MAINTENANCE(  once every
2-3 days)
 Never do maintenance while the device is
powered.
 As shown in Figure 1, materials that can cause
blocking must be cleaned by taking out the
nozzles of the water sprays.
 Clean the outer surfaces of the device with a wet
and soapy cloth. While cleaning the surface of the
device, do not use materials that can leave marks
on the surface such as detergents, wire brushes
etc. which have abrasive content.
 Clean the device warmers with an anti-lime once a
week.
 Take out and clean the pump front filter in certain
periods.
 If the device will not be used for a long time, the
surfaces need to be covered with Vaseline in thin
layers.
 Contact the authorized service in case a dangerous
situation is noticed in the device. Do not let
unqualified people to interfere the device.
PROBLEM
1-Dishes are not clean.
2-Dishes are getting broken.
3-The device does not take
water.
4-The device continuously
takes water.
POTENTIAL PROBLEMS - CAUSES - SOLUTIONS
CAUSE
-Washing arms may be stuck.
-Washing water sprays may be
blocked.
-Rinsing water sprays may be
blocked.
-Detergent concentration may be
very high or insufficient.
-Filter may be blocked.
-Washing time may be insufficient.
-Proper tray may not have been
used.
-Machine may have
overloaded.
-Water inlet valve may be closed.
-Cover may not be
completely.
-Solenoid valve may be broken.
-Pressure stat may be defective.
-Pressure stat hose may have taken
in air.
 After a certain operating duration, depending on
the hardness of water, the calcium and magnesium
in the water can cause the forming of boiler scale
on the interior surfaces of the wash tank, boilers
and interior sections of the water pumps which
can affect the devices performance. For this
reason, a boiler scale cleaning process must be
performed by a qualified technician over time.
 Maintenance of the boilers, emptying the water
inside the boiler and pump and cleaning them
must be performed
periodically.
 If there is a danger of freezing during the times
when the machine hasn't worked for a long time,
the wash pump and boiler must be emptied.
 Contact the authorized service in case a dangerous
situation is noticed in the machine. Do not permit
unqualified people to interfere the device.
-Check whether the dishes prevent arms from rotating.
-Clean the water sprays by removing the washing arm.
-Clean the water sprays by removing the rinsing arm.
-Check the hardness of water.
-Check the detergent amount.
-Remove and clean the filter.
-Select a longer wash period or repeat the same period.
-Be careful when selecting the tray.
-Comply with its capacity.
been
-Check/Open
closed -Check/Close
-Notify the authorized service.
-Notify the authorized service.
-Empty the water inside the tank and restart the
device.
12
by qualified
SOLUTION
people