Baby Trend HC07A Manuel D'instruction page 7

OPERATION
19) • Pull upward on the release levers
(located on the sides of the frame) and
push the rear legs in the direction of the
front legs until folded (Fig. 19). Chair is
now ready to put away.
DO NOT allow your child to play around
a folded high chair as it may fall.
TO UNFOLD HIGH CHAIR
Reverse steps above.
TODDLER SEAT ASSEMBLY
ATTENTION:
Recommended age for Toddler Seat use is
2-4 years of age.
Always assist your child into and out of the
seat.
Before using the toddler seat, remove tray
(step 17), lock wheels (step 15), before using
toddler seat.
20) • Completely remove the harness and
buckle from the product by threading
the strap ends through the seat back
(Fig. 20a).
• Remove extension tubes from the front
and rear legs by pushing the locking
pins in and pulling tubes (Fig. 20b).
11
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
• Reassemble the Front and Rear Legs
by inserting the tube ends into the
Upper Frame Assemblies (Fig. 20c).
NOTE: Legs are properly connected
when the locking pins are lined up with
the holes on the ends of the Upper
Frame Assemblies. Make sure the
locking pins are engaged before use.
TO REATTACH SEAT PAD
Fig. 19
Certain High Chair models are
NOTE:
packaged with the High Chair Seat Pad and
Seat Insert already attached to the Seat Back.
21) • Thread non-buckle end of Harness
Straps called Harness Attachment
Tabs through the provided slots in
the Seat Fabric, Seat Insert, Seat
Back, and Seat Base (Fig. 21). When
Harness Attachment Tabs are through
the provided slots, rotate the Harness
Attachment Tabs 90 degrees. Make
sure that the straps are firmly in place.
Fig. 20a 22) • Loop the flap on the back of the pad
over the top of the Seat Back. Connect
the Seat Pad to the Seat Back with the
two Elastic Loops. These fit over the
Attachment Tabs located near the top
harness slots (Fig. 22).
23) • Attach the bottom of Seat Pad to the
Seat Base with the two Elastic loops
located at the rear of the bottom of the
Seat Pad. These fit over the Attachment
Tabs located on the Seat Base near
where the Seat Back and Seat Base
join (Fig. 23).
Fig. 20b
TO REMOVE SEAT PAD
Reverse steps above.
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
OPERATION
Fig.20c
Fig. 21
Fig. 22
Fig. 23
12