Baby Trend PY57 Manuel D'instruction page 4

ASSEMBLY
IMPORTANT!
To ensure safe operation of your playard,
please follow these instructions carefully. Please keep these
instructions for future reference.
IMPORTANT!
Before assembly and each use, inspect this
product for damaged hardware, loose joints, missing parts or sharp
edges. NEVER use if any parts are missing or broken.
IMPORTANT!
Adult assembly is required.
TO ASSEMBLE PLAYARD
Playard
Playard must be fully assembled
ATTENTION:
and securely locked before installing or using
other accessories.
• Unzip bag and remove Playard frame (Fig.
1)
1). Undo the Fasten straps and set the
Mattress aside.
• push center down yet.
DO NOT
• Top rails must be fully erected before lowering
2)
center. Pull up one rail at a time, hold one
hand on each side of the rail and pull up
sharply, do not pull from the middle where
the center latch release is located, make sure
both tubes latch in place and each rail is rigid
(Fig. 2).
5
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Mattress
Fig. 1
Fig. 2
IMPORTANT: The center must be raised
while locking the rails. If one rail will lock
but the other side will not, unlock the rail by
squeezing the release in the center and try
again.
• Once all four top rails are locked in place,
3)
push down on the center handle (Fig. 3a).
The center mechanism automatically locks
in place.
IMPORTANT: Test each top rail by pushing
down slightly to confirm each is rigid and
securely in place before use (Fig. 3b).
• Place the Mattress on the floor of the
4)
Playard with the padded side facing up
(Fig. 4).
• Insert the hook & loop fasteners located
5)
on the underside of the Mattress through
the slots in the floor of each end of the
Playard (Fig. 5a). Fasten the hook and loop
fasteners to the underside of the Playard
floor to prevent the Mattress from moving
(Fig. 5b).
IMPORTANT: The handle located in the
center of the Playard floor MUST remain
raised (Approx. 45.7 cm or 18 inches) while
locking the side rails in place. If the center is not raised the rails will NOT lock.If
you experience difficulty and one side of the rail will lock but the other side will
not then, unlock the rail by squeezing the release in the center and try again.
If you still have difficulty, contact our Customer Service Center at 1-800-328-
7363 or visit us online at www.babytrend.com.
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 3a
Fig. 3b
Fig. 4
Fig. 5a
Fig. 5b
6