Whirlpool WHAD303AW Guide D'utilisation Et D'entretien page 8

Continuous Mode and Drain Hose
Connection (optional)
The Continuous mode allows the unit to run continuously
(depending on the selected humidity level) without having to
empty the water bucket.
To drain continuously, attach a hose (not included) for water
drainage into a floor drain.
The drain fitting uses a standard garden hose connector.
The drain hose must be below the drain port on the back
of the dehumidifier to ensure proper drainage.
NOTE: Use GHT or "garden hose thread", which has an outer
diameter of 1 / " (27 mm) and a pitch of 11.5 TPI (threads per
1
16
inch).
1.
Remove drain fitting plug
Place the dehumidifier on a level surface. Unscrew the cap on the
back of the unit to access the drain fitting.
2.
Install drain hose
Thread the drain hose (not included) onto the drain fitting on the
dehumidifier. Lead the rest of the hose to a floor drain and cut to
length (no longer than 6' long). Make sure that there are no kinks
or knots in the garden hose. Turn on the unit and press the Mode
button until set to Continuous mode.
8