Operation - Baby Trend A La Mode 3-in-1 Manuel D'instruction

OPERATION

• Wrap the back straps around the back of
the chair. Buckle the straps making sure
you hear the buckle *CLICK* closed
(Fig. 20c).
• Pull the free ends of the strap to firmly
tighten the Booster Seat to the chair
(Fig. 20d).
• Wrap bottom straps around the bottom of
the chair. Buckle the straps making sure
you hear buckle *CLICK* closed (Fig.
20e).
• Pull the free ends of the straps to firmly
tighten the Booster Seat onto the chair
(Fig. 20d).
• Check that the Booster is tightly installed
by attempting to move the Booster Seat
from side-to-side and up. The Booster
Seat should not move more than 1 inch.
TO REMOVE BOOSTER SEAT
FROM CHAIR
• Turn Booster Seat over. Slide Strap
21)
Compartments open on the bottom of
the Booster Seat (Fig. 21a).
• Fold the straps and put them in
the compartment, then slide the
Compartment Door closed (Fig. 21b).
15
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
TO REATTACH SEAT PAD
22)
Fig. 20c
Fig. 20d
23)
Fig. 20e
TO REMOVE SEAT PAD
Reverse steps above.
Fig. 21a
Fig. 21b
• Thread non-buckle end of Harness
Straps called Harness Attachment Tabs
through the provided slots in the Seat
Fabric, Body Insert, Seat Back (Fig.
22a), and Seat Base (Fig. 22b). When
Harness Attachment Tabs are through
the provided slots, rotate the Harness
Attachment Tabs 90 degrees. Make sure
that the straps are firmly in place.
• Loop the flap on the back of the pad
over the top of the Seat Back (Fig. 23a).
Connect the Seat Pad to the Seat Back
with the two Elastic Loops. These fit
over the Attachment Tabs located near
the top harness slots (Fig. 23b).
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
OPERATION
Fig. 22a
Fig. 22b
Fig. 23a
Fig. 23b
16