BASETech 1382129 Mode D'emploi page 4

a) Checking the charging status of the internal rechargeable battery
To check the charging status of the internal rechargeable battery, briefly press the operating
button (1) on the powerbank. All LEDs of the charge status indicator (4) light up briefly and the
powerbank checks the internal rechargeable battery. After that, the LEDs show the charging
status (1 LED lights up = 25 %, 2 LEDs = 50 %, 3 LEDs = 75 %, 4 LEDs = 100 %). If the LED
indicating 25 % flashes, the charging status is below 25 %.
If no USB device has been connected for charging, the powerbank will switch off after a few
seconds and the blue LEDs turn off.
b) Charging the internal rechargeable battery
• Connect the micro USB plug of the provided cable to the IN 5 V micro USB port (3) of the
powerbank.
• Connect the type A plug of the USB cable to a USB power source, e.g. of a USB power
adapter that provides a current of 1 A.
• Charging starts once the USB power source supplies current.
• One LED of the charge status indicator flashing indicates that the internal battery is being
charged. The total number of LEDs lighting up steadily indicates the current charging status
of the internal rechargeable battery.
• Charging a completely empty battery takes approx. 6 to 7 hours. The actual charging time
depends on the charging status of the rechargeable battery.
• Once the internal rechargeable battery has been fully charged, the 4 LEDs light up steadily.
Disconnect the cable from the powerbank and USB power source. The LEDs turn off.
• The powerbank is now ready for use.
c) Charging a mobile device
• Press the operating button to show the charging status of the powerbank. In case of
insufficient charge, recharge the powerbank before charging a mobile device.
• Connect the type A plug of the micro USB cable to the OUT 5 V USB-A port (2) of the
powerbank.
• Connect the micro USB plug to the micro USB port of the mobile device to be charged.
• The charging process will start.
• The LEDs of the charge status indicator will flash during charging. They indicate the remaining
capacity of the powerbank.
• Monitor the charging process. Charging cannot be cancelled by pressing the operating
button. In order to cancel the charging process, disconnect the USB cable from the mobile
device.
• Once the mobile device has been charged (or the rechargeable battery of the powerbank is
empty), the powerbank switches off. The LEDs turn off.
• Disconnect the USB cable from the product and mobile device after charging.
Maintenance and cleaning
• Never use aggressive or abrasive cleaning agents, rubbing alcohol or other chemical
solvents, as those can damage the housing or even affect the operation of the product.
• The product does not require any maintenance, do not disassemble it. The rechargeable
battery is built-in and not replaceable.
• Disconnect the product from the power supply (USB port) and any connected devices before
cleaning.
• To clean the product, a dry, soft and clean cloth is sufficient. Do not apply too much pressure
to the housing to prevent scratching. You can easily remove dust using a long-haired, soft
and clean brush.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste.
At the end of its service life, dispose of the product according to the relevant
statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the environment.
Technical data
Input voltage/current ............................. 5 V/DC, 1 A
Charging input ...................................... 1 x micro USB port
Output voltage/current .......................... 5 V/DC, 1 A
Charging output .................................... 1 x USB-A port
Internal rechargeable battery ................ Li-ion 3.7 V/DC / 5200 mAh
Housing material ................................... Aluminum
Operating and storage conditions ......... -20 to +45 °C, 20 - 85 % RH
Dimensions (W x H x D) ....................... approx. 91 x 21 x 56 mm
Weight .................................................. approx. 141 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the
technical status at the time of printing.
© Copyright 2015 by Conrad Electronic SE. V1_0915_02-LS