Publicité
Les langues disponibles
Les langues disponibles
EN
Before the first start-up:
To ensure that nothing stands in the way of a long and above all safe use of your HellBoy, it must first
be „burnt out".
The background to this procedure is that, despite the use of stainless steel for health reasons a first
burnout is strongly recommended. Any oil and grease from the production process will be removed in
this way. In addition, this initial burnout cleans the ceramic burner.
For start-up, please open the valve of the gas bottle first. Make sure that no gas is escaping from the
connection of the bottle or the connection valve on the HellBoy. Now test the function of the piezo
igniter in advance. To do this, press the start button. You will hear a „clacking" sound and - if you look
into the HellBoy - you should see sparks on the ignition wire.
If this is the case, please take your finger off the piezo igniter.
Now press - and hold - the gas control down to bypass the ignition fuse at the highest flame setting.
You will now hear the gas flowing into the ceramic burner via the venturi valve.
After about 4-6 seconds, press and hold the piezo igniter until the HellBoy ignites.
After this hold the control for about 5 seconds until the temperature is sufficient to not trigger the igni-
tion safety device.
If this is the case, please take your finger from the control.
Your HellBoy is now in operation and will within about 5 minutes heat up to about 800°C.
The ceramic tiles inside the HellBoy will now start to glow red.
To change the battery - should it be discharged - please turn off the ignition knob, remove the empty
battery and replace it with a new battery of the type Micro AA, 1.5 V.
SAFETY AND WARNING NOTICE 1:
If a „clack" of the igniter is not heard or the HellBoy does not ignite within a maximum of 10
seconds (!), please close the gas supply again, make sure that the battery (type Micro AA, 1.5
V) in the piezo igniter is not discharged and blow air into the HellBoy to remove any gas that
may have accumulated. Otherwise, there is a risk of gas deflagration when attempting to ignite
again.
Please stand behind the HellBoy when igniting! Persons must not stand in front of the HellBoy
during ignition as a flame may briefly escape from the housing during ignition and coule lead
to burn injuries!
BlackBull GmbH • Frankenhof 6 • 74245 Löwenstein • Germany • Phone: +49 7130 402 588 • bbq@blackbull-grill.de • www.blackbull-grill.de
12
Publicité
