Installing The Blades; Installing The Monting Plate - Hinkley SAWYER Manuel D'instruction

INSTALLING THE BLADES

Fig. 1

INSTALLING THE MONTING PLATE

Rubber Gasket
Adapter Plate
Screws
Bottom Cover
Fig. 2
10
| hinkley.com
Blades
Fiber Washers
Screws
Mounting Hub
(bottom of motor)
Screws
1
Insert the blade through the slot on the housing. Align the
holes on the blade and the fan motor assembly and
secure with the fiber washers and blade attachment
screws.
2
Make sure screws are TIGHT! Loose motor screws can
contribute to unnecessary hum during operation.
3
Repeat procedure for remaining blades.
NOTE:
Cordless power screwdrivers are NOT recommended,
as they usually strip the heads of the screws and
usually will not fully compress the lock washers on
the motor screws. Use a large flat blade screwdriver
for final tightening to fully compress the washers. This
will help ensure proper alignment of the blades and
noise-free, wobble-free running.
NOTE: Be sure the power is off before installing.
1 Remove one of the three screws on the mounting hub
located on the fan motor. Loosen the other 2 screws. (Do
not remove) (Fig. 2)
2
Place the key holes on the rubber gasket and adapter plate
over the 2 screws previously loosened, turn the adapter
plate until it locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws previously
loosened and the one previously removed.
3
Raise the bottom cover against the adapter plate with 2
screws until snug.
4
Restore power is ready for operation.