Operation - Hinkley CHISEL Manuel D'instruction

OPERATION

Your DC brushless motor is equipped with an
automatically learned type remote control. There is
no frequency switches on the receiver or
transmitter. The fan can start to use once the
pairing process is done.
Remove the panel from the transmitter and then
install one 23A/12V battery (included). To prevent
damage to transmitter, remove the battery if not
use for long periods of time (Fig. 16).
I, II, III, IV, V and VI button:
1
These six buttons are used to set the
fan speed as follows:
I = minimum speed
II = low speed
III = medium low speed
IV = medium speed
V = medium high speed
VI = high speed
2
button:
This button turns the fan o .
3
Reverse button:
This button is to control fan direction.
This button must be pressed while fan is
running (suggested speed IV)
4
Light button:
This button is to control optional light.
Switch the "D" and "ON" dip switch on the
1
front of transmitter to decide the light in
"ON/OFF" or "Dimmable" condition.
2
3
4
12
| hinkley.com
5
"SET" code setting button:
Follow the below steps to use the set
button. (Fig. 1)
6
ON - OFF Slide button: Power switch.
(Fig. 16)
Signal light (Fig. 2)
7
Pairing Process
With the fan's power o , restore power to the fan.
Press and hold "SET" button for about 5 seconds
and release. If optional light kit is installed, the light
kit will ash twice and the signal light on the wall
control will come on when the button is pressed.
The fan has completed the pairing process with the
wall control and is ready for use.
NOTE: A single fan can be controlled with as many
as 3 wall controls in one room. Every control will
need to repeat the pairing process based on
instructions above and all controls must be within
30 feet of the fan.
Fig. 1
Signal light
Power switch
Fig. 2