Rj45 Assignment; Touch-Remote - Kapego LED 843141 Mode D'emploi

Manual
Article No.: 843141

5. RJ45 assignment

1. WHT/ORG Data 1 +
3. WHT/GRN Data 2 +
5. WHT/BLU N/C
7. WHT/BRN Data 1 COM
8. BRN Data 2 COM

6. Touch-Remote

Operation:
Frequency:
Distance:
Dimension (LxWxH):
On/Off Switch:
Touch Wheel:
Program Button "P":
Speed Button "S":
Dim Button "B":
White Button „W":
1. Connect Touch-Controller with White RF Controller
a. Switch on the Power of the RGB RF Controller and wait ca. 1s and then push the
"ON" button on the Touch-Controller, after that the LED flashes up 3 times, then the
Touch-Controller and the Controller are connected.
b. If this step isn't working please try again.
2. Disconnect Touch-Controller from RGB RF Controller
a. Switch on the LED bulb and wait ca. 1s and then hold the "ON" button again till the
LED flashes up 9 times, then the Touch-Controller and the RGB RF Controller are
disconnected.
b. Now you can address the White RF Controller again with the same or another Touch-
Controller.
1 - WHT/ORG Data 1 +
3 - WHT/GRN Data 2 +
5 WHT/BLU
7 - WHT/BRN Data 1 COM
8 - BRN
2x AAA Batterien (excl.)
2,4 GHz
ca. 20 m (inside)
110 x 52 x 20 mm
addressing with "ON"
RGB
Change the program
Speed control
Brightness
White Dimmer
5
1
3
5
N/C
7
8
Data 2 COM
RJ 45