Programming
Interrupting the descaling cycle
If the descaling cycle is interrupted by the machine
switching off, it is resumed when the machine is
switched on again.
The descaling cycle may be interrupted by pressing
the
key; the display shows:
MACHINE IS DESCALING
INTERRUPTED
press the
key and the descaling cycle resumes. If
the
key and the
key are pressed, the display
shows:
DESCAL. INTERRUPTED
EMPTY WATERTANK
Warning! After the operation, empty the water tank of
the descaling solution and wash it with fresh drinking
water. The machine's circuit must be washed with a
rinse cycle.
Proceed as for a normal rinse cycle as described at
point 8 of the previous chapter.
Setting machine functions
The user can change a number of the machine's
operating parameters according to personal
preference.
These functions are:
Standby, Rinsing, Language, Contrast, Water
hardness, Water filter, Temperature, Coffee Size,
Quantity of Water, Steam time, Espresso flavour,
Coffee flavour, Long coffee flavour, Pre-brewing,
Counter, Timer, Clock and Washing cycle.
MENU command
To change operating parameters, enter programming
mode with the
key, when the machine is at rest.
In programming, select the required function and press
the
key. This scrolls you through the functions
available on the machine.
To exit the programming, press the
Changing individual functions
Select the required function by pressing the
key.
Enable the required function with the
through the variables using the
the required variable, press
Note: the
key interrupts programming at any time
without saving changes. This operation is only possible
before pressing the
key.
key.
key. Scroll
key. To save
key.
15
NA