ADEO Services NHD52+1DISC(E14) Mode D'emploi page 50

EN
6. Maintenance / Cleaning .
Always disconnect the appliance before cleaning or
doing maintenance
Never use a wet sponge to clean the appliance
In order to not damage the product, it is advisable to
use adapted equipment to the fragile surfaces and
products slowing the wear on the appliance
7. Repair Guide
TROUBLE
Fan will not
start
Fan sounds
noisy
Mechanical
noise
49
PROBABLE CAUSE
Fuse or circuit
breaker blown
Loose power line
connections to the
fan
Speed controller
not in correct
position
Top canopy
touching ceiling
Loose fan blades
screws
Ceiling fan not
secured against
ceiling
Incorrect speed
controller
SUGGEST REMEDY
Check main and
branch circuit fuses
or circuit breakers
Check line wire
connections to fan
Check speed
controller's position
Lower canopy from
ceiling to ensure
minimum 3mm
clearance
Re-tighten all screws
on fan blades but
never over-tighten
Re-tighten all screws
in the hanging
bracket or plate
Change the controller
to the one supplied
Allow at least for 8
hours setting-in
period