TFA HiTRAX Step 3D Instructions D'utilisation page 4


With 3 D sensor - can be placed anywhere (belt, pocket, bag...)

Adjustable Step length (cm- inch)

Clock (12/24 hour format)

Calorie consumption/ fatburning (kcal – g/oz)

Distance (km - mile)

Speed (km/h - mile/h)

Temperature: °C/°F

7-day-storage

Incl. battery (CR 2032) Nylon case with clip

2. Elements
A: Display
B: REC/▲ button
C: SET/TMP button
D: MODE/ ▼ button
E: ON/OFF button
F: Battery compartment
G: RESET button
H: Eyelet for cord
3. Getting started

Pull off the protection foil on the display.

Open the battery compartment by turning the lid counterclockwise using a coin and remove the
insulation strip.

Close the battery compartment again.

All LCD segments will light up for about a few seconds.

The unit is now ready to use.
4. Basic setting

After battery was inserted or press and hold SET/TMP button for 3 seconds, you will enter the basic
setting mode.

°C flashes on the display.

Press MODE/ ▼ button to change the temperature unit from °C or °F.

In this case the other units change correspondingly.

Confirm with SET/TMP button.

0:00 appears on the display and the hour digit is flashing.

Press REC/▲ button (+ 1 hour) or MODE/ ▼ button (- 1 hour) to adjust the hours.

Confirm with SET/TMP button.

The minutes are flashing. Set minutes in the same way.

Confirm with SET/TMP button.

The step length - adjustment flashes (default: 60 cm/23,5 in).

Press REC/▲ button (+ 1 cm) or MODE/ ▼ button (- 1 cm) to adjust the step length.

Confirm with SET/TMP button.

The weight - adjustment flashes (default: 50 kg/110 lb).

Press REC/▲ button (+ 1 kg) or MODE/ ▼ button (- 1 kg) to adjust the weight.

Confirm with SET/TMP button.

The unit is now ready to use.

Hold and press MODE/ ▼ button or REC/▲ button for a fast count.
5. Step counting

Press MODE/ ▼ button (3 secondes), if desired, to reset the day data.

0 Step appears on the display.
Caution:
Please note that the first steps do not immediately appear on the display. The pedometer will start to count after
10 constant steps and will add on the first steps directly.
6. Indication time/temperature

Press SET/TMP button and the actual temperature appears on the display (5 secondes).
4