Miles Industries G30ZRHTT Mode D'emploi page 2

You can set your fireplace to come on before you waken and turn after you leave home and
turn on again just before you come home and turn off after going to bed.
You can leave it like this for the heating season.
Here's what you do:
1. Decide what temperature you want your fireplace to be at; also decide what time
you want your fireplace to turn on and off; then decide what time you want it to
come back on and off in the afternoon or evening. For the first few times you set
the timer, it's handy to write these times down.
2. Set the temperature (just as you did in the section on "setting the temperature."
3. Press the "timer" button and hold until "p1*" appears and flashes. Let go. While
flashing, push the "up" button to the hour you want your fireplace to turn on in the
morning and the "down" button to the minute.
4. Press "timer" to P1 (moon) and proceed as in step 3, to turn off time.
5. Press "timer" again, and you get "P2*" to set the time to come back on in the
afternoon. Set the time.
6. Press "timer" again to get P2 (moon) to set the time for your fireplace to go off in
the evening.
7. Do nothing else, and your fireplace will give you steady, even heat at the
temperatures and times you set.
f i r e - p a r t s . c o m
Note: If you want to set your fireplace for only 1 time on and off, set P2 for the same times
as P1.
To temporarily override the timer setting, just press "auto" or "manual". Press "timer" when
you want to go back to your settings.
When your remote control displays "batt" you need to replace your battery with a new
9 volt alkaline battery - 6LR61/MN1604.
Programming Time and Temperature
Milesfireplaces.com
© Copyright Miles Industries Ltd., 2005
Oct 05