Spector&Co SPECTECH T143 Mode D'emploi page 2

T143 Product Map
To wirelessly charge a wireless enabled smartphone device using the T143
1. Make sure your smartphone has integrated wireless capability or is equipped with wireless charging
adapter
2. Insert the micro USB output of charging cable (included) into the input port (
connect USB output of the cable to a certified wall adapter (not included)
3. The red & blue LED will flash once to indicate that the T143 is ready to wirelessly charge your
smartphone. Center your electronic device over the
charging your device & may remain lit once fully charged.
integrated wireless capability can deactivate the blue LED on the T143 once the device is fully
charged)
4. To stop charging, remove your electronic device from the
charging cable
NOTE:
- only smartphones equipped with wireless charging capabilities are able to use the wireless charging of the
T143
- the wireless charging dock of T143 will activate only when it is connected to a certified A/C adapter (not
included)
CAUTION:
Risk of Fire and Burns, don't open, crush, disassemble and dispose of in fire. Accessible surfaces held or
touched for short periods only. Don't heat above 50°C or Incinerate. Follow Manufacturer's Instructions
Wireless charging dock
icon. A blue LED will remain lit while
(NOTE: some smartphones with
icon on T143 and disconnect the
LED lights
Micro-USB input port
icon) of T143 &