Publicité
Les langues disponibles
Les langues disponibles
T144 Operation
1. Unscrew the adjustable knob located on the back of T144 until loose
2. Insert the ball joint into T144 & tighten air vent clip
adjust screen view of their smartphone when using the T144. Do not overtighten the adjustable
knob)
3. Press & hold the release button (see # 7 in Product Map above)
4. Clip the T144 onto the air vent of your vehicle
5. Insert the provided micro-USB cable into the T144 prior to connecting the USB plug to an USB output
of your vehicle (note: a certified car adapter [not included] is required if an USB output port is not
available in your vehicle)
To wireless charge a smartphone using the T144
** Make sure your smartphone has integrated wireless charging capability or is equipped with wireless
charging adapter (NOTE: some smartphones with integrate wireless capability may require users to
manually enable wireless charging in the smartphone's settings)
1. A flashing blue Led indicates that the T144 wireless charging capability is activated & a solid blue
LED indicates that the T144 is ready to wireless charge a smartphone
2. Place your smartphone between the adjustable brackets of the T144.
automatically be prompted.
smartphone once it is 100% fully charged)
3. To stop charging, remove smartphone from the T144
CAUTION:
Risk of Fire and Burns, don't open, crush, disassemble and dispose of in fire. Accessible surfaces held or
touched for short periods only. Don't heat above 50 °C or Incinerate. Follow Manufacturer's Instructions
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a class B digital device pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation if this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
(NOTE: assembled ball joint allows user to
(NOTE: wireless charging will automatically stop by your
Wireless charging will
Publicité
